408-10390 Datasheet, PDF (17/18 Pages) TE Connectivity Ltd – Ocean side-feed applicators are available with either a mechanical feed, air feed, or servo feed system

408-10390
8. Re-install the single revolution limiter bolt back into the ram. Make sure that the numbered wire crimp
height adjustment dial lines up properly with the indicator wedge cut-out pointing to the zero on the
numbered wire crimp disc.
NOTE
If necessary, loosen the 3 setscrews holding the numbered wire crimp and height adjustment dial to the ram post and turn it
until the dial indicates a zero reading, then re-tighten the 3 setscrews against the ram post.
CAUTION
When tightening the setscrews, turn each setscrew 60 – 90 degrees after contacting the center hub. Tightening more than 90
degrees can compromise the numbered wire crimp height adjustment dial and cause it to crack. Also, apply Loctite 222
threadlocker to the setscrews before tightening them.
9. Put the ram assembly back into the applicator.
10. Install applicator in machine, and make some test crimps. Measure the crimp heights, and check them
against the crimp height specified on the applicator parts list. If the crimp heights are within specified
tolerances, the applicator may be placed in service. If not, repeat this procedure, starting with step 1.
6.7. Counter Magnet Orientation
The applicator counter magnet will properly actuate the applicator counter (shown in Figure 5) only if it is
installed with the correct side facing out from the ram. If for any reason the magnet is removed, it will need to
be determined (before re-installing the magnet in the ram) which side of the magnet actuates the counter by
running the magnet behind the counter by hand to see which side of the magnet actuates the counter properly.
6.8. Wire Depressor Accessory
Refer to Figure 12 to determine the parts required to add this accessory if it is not installed on the applicator
from the factory.
7. CLEANING, LUBRICATION, AND STORAGE
For best performance and minimum downtime, the applicator should be cleaned (daily and monthly), inspected,
lubricated, and stored as indicated in instruction sheet 408-8059.
8. REVISION SUMMARY
Revisions to this Instruction Sheet include:
 Added to Figure 12: Note: When crimper spacer PN 455888-5 or 455888-6 are fitted to the applicator,
ONLY the wire depressor and corresponding spacer need to be used.
Loctite is a trademark.
Rev M1
17 of 18