408-10390 Datasheet, PDF (18/18 Pages) TE Connectivity Ltd – Ocean side-feed applicators are available with either a mechanical feed, air feed, or servo feed system

Part Number-to-Crimper Spacer
Thickness Cross-Reference
PART
NUMBER
455888-1
455888-2
455888-3
455888-4
455888-5
455888-6
455888-7
455888-8
455888-9
1-455888-0
1-455888-1
1-455888-2
1-455888-3
1-455888-4
1-455888-5
1-455888-6
1-455888-7
1-455888-8
1-455888-9
2-455888-0
2-455888-1
2-455888-2
2-455888-3
2-455888-3
2-455888-4
2-455888-5
2-455888-7
2-455888-8
2-455888-9
3-455888-2
3-455888-7
7-455888-2
THICKNESS
mm [in.]
0.25 [.010]
0.30 [.012]
0.38 [.015]
0.51 [.020]
0.66 [.026]
0.79 [.031]
0.89 [.035]
1.02 [.040]
1.14 [.045]
1.27 [.050]
1.40 [.055]
1.52 [.060]
1.57 [.062]
1.65 [.065]
1.78 [.070]
1.91 [.075]
2.03 [.080]
2.16 [.085]
2.29 [.090]
2.36 [.093]
2.41 [.095]
2.54 [.100]
2.67 [.105]
2.67 [.105]
2.79 [.110]
2.92 [.115]
3.18 [.125]
4.37 [.172]
5.08 [.200]
3.63 [.143]
3.56 [.140]
4.83 [.190]
Se = Existing Crimper Spacer Thickness
(See Cross-Reference for
Part Number-to-Crimper Spacer Thickness)
408-10390
Choose Wire Depressor
Based on Wire Size Range
Sr = Replacement Crimper
Spacer Thickness
Wire Depressor Washer Spacer
PN 2119943-1 Required
Step 1
Determine replacement crimper spacer thickness using the following formula:
Se - 0.64 mm [.025 in.] = Sr
Note: Use the table to determine which crimper spacer or combination of crimper
spacers is required to achieve proper replacement crimper spacer thickness.
Note: The existing crimper spacer must be at least 0.64 mm [.025 in.] thick in order
to add a wire depressor to an existing applicator.
Step 2
Choose a wire depressor based on the wire size range:
PN 2119791-5 0.008-1.305 mm² [38-16 AWG]
PN 2119791-9 0.150-5.270 mm² [20-10 AWG]
Step 3
Order replacement components:
Washer spacer PN 2119943-1
Wire depressor (chosen in Step 2)
Crimper spacer/spacers (chosen in Step 1)
Note: When crimper spacer PN 455888-5 or 455888-6 are fitted to the applicator,
ONLY the wire depressor and corresponding spacer need to be used.
Figure 12
Rev M1
18 of 18