408-10390 Datasheet, PDF (16/18 Pages) TE Connectivity Ltd – Ocean side-feed applicators are available with either a mechanical feed, air feed, or servo feed system

Ram Post
(Atlantic)
Replacing Crimp Height Shim
(Pacific)
Numbered Wire Crimp
Height Adjustment Dial
Spacer
Shim
Adjustment Bolt
Single Revolution
Limiter Bolt
408-10390
Ram Clamp
NOTE: Pacific
Applicators Only
When Installing
Setscrews, 3 of 5
Holes Must be
Used that Will Not
Interfere with Ramp
Clamp Device
Figure 11
3. Hold the ram assembly with the ram post (or clamp, depending on the applicator style) pointing up.
Then unscrew the ram post (or clamp) from the ram, exposing the adjustment screw assembly. If
necessary, the ram may be placed in a soft jaw vise to free both hands for turning the ram post (or
clamp).
4. Loosen and unscrew the ram post (or clamp) from the adjustment bolt to access the shim(s).
5. Place the shim(s) having the thickness determined in step 1 on the ram post (or clamp). If the old
washer is broken and must be replaced, measure the thickness of the broken washer with a
micrometer. Add this measurement to the amount to be added (determined in step 1), and select the
new shim(s) having this thickness. Place the new shim(s) on the ram post (or clamp).
6. Re-tighten the ram post to the adjustment bolt with the spacer and new shim(s) placed in between.
NOTE
Lightly grease the threads of the adjustment bolt with the recommended greases before re-assembling.
7. Hold the ram with the hole facing up, assemble the adjustment screw assembly into the ram, and
tighten it by hand until it bottoms in the ram. Make sure not to tighten the adjustment screw assembly.
Just turn it in the assembly until it stops.
Rev M1
16 of 18