408-10390 Datasheet, PDF (2/18 Pages) TE Connectivity Ltd – Ocean side-feed applicators are available with either a mechanical feed, air feed, or servo feed system

408-10390
Air Feed Applicator
Air Feed Cam
Air Supply Connection
Retract Speed Control
Forward Speed Control
Mounting Screw
(2 Places)
Feed Stroke/Feed Forward Position
Adjustment
End Cap
End Cap Bolt
(2 Places)
Feed Pawl
Feed Arm
Detent Screw
(2 Places)
Feed Backstroke/Rear Position
Adjustment
Figure 2
Each applicator is individually designed for specific terminals. The wire crimp height and insulation crimp height
can be adjusted to accommodate different wire sizes and insulation ranges, respectively. The applicator is also
designed to accept modular-feed packages. The feeder assembly can be removed from the applicator and
replaced with any different style; mechanical, air, or servo feed; depending on the requirements (see Figure 3).
To change to a different feed type, use retro-fit kit PN 2119949 for the mechanical terminal feeder, retro-fit kit
PN 2119950 for the pneumatic terminal feeder, and retro-fit kit PN 2119951 for the servo terminal feeder.
Changing Feeder Assembly
Servo Feeder Latch Plate
Servo Terminal
Feeder Assembly
Push Rod
Bushing
Applicator
Pneumatic Terminal
Feeder Assembly
Mechanical Terminal
Feeder Assembly
Rev M1
Figure 3
2 of 18