STM8L151X6 Datasheet, PDF (1/146 Pages) STMicroelectronics – Operating conditions

STM8L151x6/8 STM8L152x6/8
8-bit ultra-low-power MCU, up to 64 KB Flash, 2 KB data EEPROM,
RTC, LCD, timers, USARTs, I2C, SPIs, ADC, DAC, comparators
Datasheet - production data
Features
• Operating conditions
– Operating power supply: 1.65 to 3.6 V
(without BOR), 1.8 to 3.6 V (with BOR)
– Temp. range: -40 to 85, 105 or 125 °C
• Low-power features
– 5 low-power modes: Wait, Low-power run
(5.9 µA), Low-power wait (3 µA), Active-
halt with full RTC (1.4 µA), Halt (400 nA)
– Consumption: 200 µA/MHz+330 µA
– Fast wake up from Halt mode (4.7 µs)
– Ultra low leakage per I/0: 50 nA
• Advanced STM8 core
– Harvard architecture and 3-stage pipeline
– Max freq: 16 MHz, 16 CISC MIPS peak
– Up to 40 external interrupt sources
• Reset and supply management
– Low-power, ultra safe BOR reset with five
programmable thresholds
– Ultra-low-power POR/PDR
– Programmable voltage detector (PVD)
• Clock management
– 32 kHz and 1-16 MHz crystal oscillators
– Internal 16 MHz factory-trimmed RC and
38 kHz low consumption RC
– Clock security system
• Low-power RTC
– BCD calendar with alarm interrupt,
– Digital calibration with +/- 0.5ppm accuracy
– Advanced anti-tamper detection
• LCD: 8x40 or 4x44 w/ step-up converter
• DMA
– 4 ch. for ADC, DACs, SPIs, I²C, USARTs,
Timers, 1 ch. for memory-to-memory
• 2x12-bit DAC (dual mode) with output buffer
• 12-bit ADC up to 1 Msps/28 channels
– Temp. sensor and internal ref. voltage
&63
LQFP80 (14x14mm)
LQFP64 (10x10mm)
LQFP48 (7x7mm)
UFQFPN48
7x7mm
WLCSP32
1.913x3.329 mm
• Memories
– Up to 64 KB of Flash memory with up to
2KB of data EEPROM with ECC and RWW
– Flexible write/read protection modes
– Up to 4 KB of RAM
• 2 ultra-low-power comparators
– 1 with fixed threshold and 1 rail to rail
– Wake up capability
• Timers
– Three 16-bit timers with 2 channels (IC,
OC, PWM), quadrature encoder
– One 16-bit advanced control timer with 3
channels, supporting motor control
– One 8-bit timer with 7-bit prescaler
– One window, one independent watchdog
– Beeper timer with 1, 2 or 4 kHz frequencies
• Communication interfaces
– Two synchronous serial interface (SPI)
– Fast I²C 400 kHz SMBus and PMBus
– Three USARTs (ISO 7816 interface + IrDA)
• Up to 67 I/Os, all mappable on interrupt vectors
• Up to 16 capacitive sensing channels
supporting touchkey, proximity, linear touch
and rotary touch sensors
• Fast on-chip programming and non-intrusive
debugging with SWIM, Bootloader using
USART
• 96-bit unique ID
Table 1. Device summary
Reference
STM8L151x6/8
STM8L152x6/8
Part number
STM8L151R6, STM8L151C8, STM8L151M8,
STM8L151R8
STM8L152R6, STM8L152C8, STM8L152K8,
STM8L152M8, STM8L152R8
February 2017
This is information on a product in full production.
DocID17943 Rev 10
1/146
www.st.com