COM20022I_06 Datasheet, PDF (70/82 Pages) SMSC Corporation – 10 Mbps ARCNET (ANSI 878.1) Controller with 2Kx8 On-Board RAM

10 Mbps ARCNET (ANSI 878.1) Controller with 2Kx8 On-Board RAM
Datasheet
nIOCS16
t12
t13
VALID VALUE
A0-A2
VALID
t1
t2
nCS
t4
DIR
t3
nDS
D0-D15
t5
t7
t10
t8
t11
Note 2
t6**
t9
t6
VALID DATA
CASE 2: BUSTMG pin = LOW
Parameter
t1 Address Setup to nDS Active
t2 Address Hold from nDS Inactive
t3 nCS Setup to nDS Active
t4 nCS Hold from nDS Inactive
t5 DIR Setup to nDS Active
t6 Cycle Time (nDS to Next )**
t7 DIR Hold from nDS Inactive
t8 Valid Data Setup to nDS High
t9 Data Hold from nDS High
t10 nDS Low Width
t11 nDS High Width
t12 nIOCS16 Output Delay from nCS Low
t13 nIOCS16 Hold Delay from nCS High
min
0
0
0
0
10
4TARB*
10
30
10
65
30
0*****
max
40****
units
nS
nS
nS
nS
nS
nS
nS
nS
nS
nS
nS
nS
nS
* _{TARB is the Arbitration Clock Period}
TARB is identical to Topr if SLOW ARB = 0
TARB is twice Topr if SLOW ARB = 1
Topr is the period of operation clock. It depends on CKUP1 and CKUP0 bits
**** t12 is measured from the latest active (valid) timing among nCS, A0-A2.
***** _{t13 is measured from the earliest inactive (invalid) timing among nCS, A0-A2.}
Note 1: The Microcontroller typically accesses the COM20022 on every other cycle.
Therefore, the cycle time specified in the microcontroller's datasheet
should be doubled when considering back-to-back COM20022 cycles.
**Note 2: Any cycle occurring after a write to the Address Pointer Low Register
requires a minimum of 4TARB from the trailing edge of nDS to the leading edge
of the next nDS.
Write cycle for Address Pointer Low Register occurring after an access to
Data Register requires a minimum of 5TARB from the trailing edge of nDS to
the leading edge of the next nDS.
Note 2 is applied to an access to Data Register by DMA transfer.
Figure 8.12 - Non-Multiplexed Bus, 68XX-Like Control Signals; Write Cycle
Revision 02-27-06
Page 70
DATASHEET
SMSC COM20022I