COM20022I-3V Datasheet, PDF (57/83 Pages) SMSC Corporation – 10 Mbps ARCNET (ANSI 878.1) Controller with 2Kx8 On-Board RAM

10 Mbps ARCNET (ANSI 878.1) Controller with 2Kx8 On-Board RAM
Datasheet
Chapter 7 Operational Description
7.1 Maximum Guaranteed Ratings*
Operating Temperature Range ...............................................................................................-40^oC to +85^oC
Storage Temperature Range ................................................................................................-55^oC to +150^oC
Lead Temperature (soldering, 10 seconds) ....................................................................................... +325 ^oC
Positive Voltage on any pin, with respect to ground ........................................................................V_DD+0.3V
Negative Voltage on any pin, with respect to ground ............................................................................. -0.3V
Maximum V_DD .......................................................................................................................................... +7V
* Stresses above those listed may cause permanent damage to the device. This is a stress rating only and
functional operation of the device at these or any other condition above those indicated in the operational
sections of this specification is not implied.
Note:
When powering this device from laboratory or system power supplies, it is important that the Absolute
Maximum Ratings not be exceeded or device failure can result. Some power supplies exhibit voltage
spikes or "glitches" on their outputs when the AC power is switched on or off. In addition, voltage
transients on the AC power line may appear on the DC output. If this possibility exists it is suggested that
a clamp circuit be used.
7.2 DC Electrical Characteristics
V_DD= 3.3v±5%
COM20022I 3V: T_A=0^oC to +70^oC, COM20022I 3V: T_A=-40^oC to +85^oC
PARAMETER
SYMBOL
MIN
TYP
MAX
UNIT
Low Input Voltage 1
V_IL1
(All inputs except A2,
0.6
V
XTAL1, nRESET, nRD,
nWR, nREFEX and RXIN)
High Input Voltage 1
V_IH1
2.0
V
(All inputs except A2,
XTAL1, nRESET, nRD,
nWR, nREFEX and RXIN)
Low Input Voltage 2
(XTAL1)
V_IL2
0.6
1.0
V
High Input Voltage 2
V_IH2
2.4
V
(XTAL1)
COMMENT
TTL Clock Input
SMSC COM20022I 3V
Page 57
DATASHEET
Revision 02-27-06