COM20022I-3V Datasheet, PDF (34/83 Pages) SMSC Corporation – 10 Mbps ARCNET (ANSI 878.1) Controller with 2Kx8 On-Board RAM

10 Mbps ARCNET (ANSI 878.1) Controller with 2Kx8 On-Board RAM
Datasheet
6.2.8 Command Register
Execution of commands are initiated by performing microcontroller writes to this register. Any
combinations of written data other than those listed in Table 6.7 are not permitted and may result in
incorrect chip and/or network operation.
6.2.9 Address Pointer Registers
These read/write registers are each 8-bits wide and are used for addressing the internal RAM. New pointer
addresses should be written by first writing to the High Register and then writing to the Low Register
because writing to the Low Register loads the address. The contents of the Address Pointer High and Low
Registers are undefined upon hardware reset. Writing to Address Pointer low loads the address.
The DMAEN bit (new to the COM20022I 3V) is located at bit 3 of the ADDRESS PTR HIGH register. The
DMAEN bit is used to Disable/Enable the assertion of the DMA Request (DREQ pin) after writing the
Address Pointer Low register. The SWAP bit (new to the COM20022I 3V) is located at bit 0 of Address
Pointer Low register. The SWAP bit is used to swap the upper and lower data byte. When 16 bit access is
enabled, (W16=1), A0 becomes the SWAP bit.
6.2.10 Configuration Register
The Configuration Register is a read/write register which is used to configure the different modes of the
COM20022I 3V. The Configuration Register defaults to the value 0001 1000 upon hardware reset only.
SUBAD0 and SUBAD1 point to the selection in Register 7.
6.2.11 Sub-Address Register
The sub-address register is new to the COM20022I 3V, previously a reserved register. Bits 2, 1 and 0 are
used to select one of the registers assigned to address 7h. SUBAD1 and SUBAD0. They are exactly
same as those in the Configuration register. If the SUBAD1 and SUBAD0 bits in the Configuration register
are changed, the SUBAD1and SUBAD0 in the Sub-Address register are also changed. SUBAD2 is a new
sub-address bit. It Is used to access the 3 new Set Up registers, SETUP2, BUS CONTROL and DMA
COUNT. These registers are selected by setting SUBAD2=1. The SUBAD2 bit is cleared automatically by
writing the Configuration register.
Write Bits[7:3] to ‘0’ for proper operation.
6.2.12 Setup 1 Register
The Setup 1 Register is a read/write 8-bit register accessed when the Sub Address Bits are set up
accordingly (see the bit definitions of the Configuration Register). The Setup 1 Register allows the user to
change the network speed (data rate) or the arbitration speed independently, invoke the Receive All
feature and change the nPULSE1 driver type. The data rate may be slowed to 156.25Kbps and/or the
arbitration speed may be slowed by a factor of two. The Setup 1 Register defaults to the value 0000 0000
upon hardware reset only.
6.2.13 Setup 2 Register
The Setup 2 Register is new to the COM20022I 3V. It is an 8-bit read/write register accessed when the
Sub Address Bits SUBAD[2:0] are set up accordingly (see the bit definitions of the Sub Address Register).
This register contains bits for various functions. The CKUP1,0 bits select the clock to be generated from
Revision 02-27-06
Page 34
DATASHEET
SMSC COM20022I 3V