LAN9116_08 Datasheet, PDF (16/132 Pages) SMSC Corporation – Highly Efficient Single-Chip 10/100 Non-PCI Ethernet Controller

Highly Efficient Single-Chip 10/100 Non-PCI Ethernet Controller
Datasheet
Table 2.3 LAN Interface Signals
PIN
BUFFER
NUM
NO.
NAME
SYMBOL
TYPE
PINS
DESCRIPTION
79
TXP
TPO+
AO
78
TXN
TPO-
AO
83
RXP
TPI+
AI
82
RXN
TPI-
AI
87
PHY External Bias
EXRES1
AI
Resistor
1
Twisted Pair Transmit Output,
Positive
1
Twisted Pair Transmit Output,
Negative
1
Twisted Pair Receive Input, Positive
1
Twisted Pair Receive Input, Negative
1
Must be connected to ground through
a 12.4K ohm 1% resistor.
Table 2.4 Serial EEPROM Interface Signals
PIN
NO.
NAME
SYMBOL
BUFFER
TYPE
NUM
PINS
DESCRIPTION
67
EEPROM Data,
EEDIO/GPO3/
I/O8
GPO3, TX_EN, TX_EN/TX_CLK
TX_CLK,
(D32/nD16)
D32/nD16
68
EEPROM Chip
EECS
O8
Select
1
EEPROM Data: This bi-directional
pin can be connected to a serial
EEPROM DIO. This is optional.
General Purpose Output 3: This
pin can also function as a general
purpose output, or it can be
configured to monitor the TX_EN or
TX_CLK signals on the internal MII
port. When configured as a GPO
signal, or as a TX_EN/TX_CLK
monitor, the EECS pin is deasserted
so as to never unintentionally access
the serial EEPROM. This signal
cannot function as a general-
purpose input.
Data Bus Width Select: This signal
also functions as a configuration
input on power-up and is used to
select the host bus data width. Upon
deassertion of reset, the value of the
input is latched. When high, a 32-bit
data bus is utilized. When low, a 16-
bit interface is utilized.
1
Serial EEPROM chip select.
Revision 1.5 (07-11-08)
16
DATASHEET
SMSC LAN9116