LAN9116_08 Datasheet, PDF (104/132 Pages) SMSC Corporation – Highly Efficient Single-Chip 10/100 Non-PCI Ethernet Controller

5.5
PHY Registers
Highly Efficient Single-Chip 10/100 Non-PCI Ethernet Controller
Datasheet
The PHY registers are not memory mapped. These registers are accessed indirectly through the MAC
via the MII_ACC and MII_DATA registers. An index must be used to access individual PHY registers.
PHY Register Indexes are shown in Table 5.8, "LAN9116 PHY Control and Status Register"below.
Note: The NASR (Not Affected by Software Reset) designation is only applicable when bit 15 of
the PHY Basic Control Register (Reset) is set.
INDEX
(IN DECIMAL)
0
1
2
3
4
5
6
17
18
27
29
30
31
Table 5.8 LAN9116 PHY Control and Status Register
PHY CONTROL AND STATUS REGISTERS
REGISTER NAME
Basic Control Register
Basic Status Register
PHY Identifier 1
PHY Identifier 2
Auto-Negotiation Advertisement Register
Auto-Negotiation Link Partner Ability Register
Auto-Negotiation Expansion Register
Mode Control/Status Register
Special Modes Register
Special Control/Status Indications
Interrupt Source Register
Interrupt Mask Register
PHY Special Control/Status Register
Revision 1.5 (07-11-08)
104
DATASHEET
SMSC LAN9116