English
Language : 

LAN9218I_12 Datasheet, PDF (134/134 Pages) SMSC Corporation – High-Performance Single-Chip 10/100 Ethernet Controller with HP Auto-MDIX and Industrial Temperature Support
High-Performance Single-Chip 10/100 Ethernet Controller with HP Auto-MDIX and Industrial Temperature Support
Datasheet
Table 9.1 Customer Revision History (continued)
REVISION LEVEL & DATE SECTION/FIGURE/ENTRY
CORRECTION
Rev. 2.2
(06-19-08)
Rev. 2.2
(06-10-08)
Rev. 2.1
(05-13-08)
Rev. 2.0
(04-11-08)
Rev. 1.93
(11-27-07)
Rev. 1.92
(10-22-07)
Figure 1.2, "Internal Block
Diagram"
Diagram redone. The second PLL regulator was
added to the diagram.
The word “Core” was added to the regulator block
title.
Added note to VDD_CORE/VDD18CORE and
VDD_PLL that states “These pins must not be
used to supply power to other external devices.”
Auto-negotiation
Bits 9 and 15 relabeled as Reserved, Read-Only
Advertisement on page 107 (RO), with a default of 0.
Auto-negotiation
Advertisement on page 107
Fixed definition of bits 11:10 when equal to “11” by
adding “advertise support for..” to beginning of
definition. Also added note stating “When both
symmetric PAUSE and asymmetric PAUSE
support are advertised, the device will only be
configured to, at most, one of the two settings
upon auto-negotiation completion.”
Section 3.5, "Wake-up
Frame Detection," on
page 26 and Section 5.4.1,
"MAC_CR—MAC Control
Register," on page 94
Added note: “When wake-up frame detection is
enabled via the WUEN bit of the WUCSR—Wake-
up Control and Status Register, a broadcast wake-
up frame will wake-up the device despite the state
of the Disable Broadcast Frame (BCAST) bit in the
MAC_CR—MAC Control Register.”
Section 5.4.12,
"WUCSR—Wake-up Control
and Status Register," on
page 103
Fixed typo in bit 9: “... Mac Address [1:0] bit set to
0.” was changed to “...Mac Address [0] bit set to 0.”
Section 1.1, "Block
Diagram"
Removed the system memory block and arrow
above the microprocessor/ microcontroller
Section 7.6, "DC Electrical Input leakage current values added
Specifications," on page 129
Ordering Information
Added temperature range information
Chapter 2 Pin Description
and Configurationon
page 14
EECLK pin description in
Chapter 2 Pin Description
and Configurationon
page 14
Pin assignment information re-organized into
separate table.
Note added to EECLK pin description to indicate
proper usage.
Revision 2.9 (03-01-12)
134
DATASHEET
SMSC LAN9218i