English
Language : 

SDBC-DK3UG Datasheet, PDF (28/76 Pages) Silicon Laboratories – 4 buttons and 4 LEDs for custom purposes
SDBC-DK3 UG
Figure 31. Setup Screen (3 of 4)
1. Select the appropriate output power required for the test.
2. Press <GO> to move on from this screen.
Note: If an alternate testcard is used, such as the antenna diversity test cards, users may see slightly different screen shots
than those shown. Users must turn off the diversity function by selecting “antenna 1” and connecting to the appropriate
antenna connector using 50  coaxial cable.
Figure 32. Setup Screen (4 of 4)
1. Parameters on setup screen 4 are not relevant to CW evaluations. Silicon Labs recommends leaving them at
their default values.
2. Press <GO> to move on from this screen.
In Figure 33, the runtime screen will summarize the current valid settings.
Figure 33. Runtime Screen
28
Rev. 0.4