S-1740 Datasheet, PDF (13/47 Pages) ABLIC Inc. – 5.5 V INPUT, 100 mA VOLTAGE REGULATOR WITH SUPPLY VOLTAGE DIVIDED OUTPUT

POWER MONITORING OUTPUT, 5.5 V INPUT, 100 mA CMOS VOLTAGE REGULATOR WITH 0.5 μA SUPER LOW CURRENT CONSUMPTION
Rev.1.1_00
S-1740/1741 Series
 Condition of Application
Input capacitor (C_IN):
Output capacitor (C_L):
Output capacitor (C_PM):
A ceramic capacitor with capacitance of 1.0 μF or more is recommended.
A ceramic capacitor with capacitance of 1.0 μF to 100 μF is recommended.
A ceramic capacitor with capacitance of 100 nF to 220 nF is recommended.
Caution Generally, in a voltage regulator, an oscillation may occur depending on the selection of the external
parts. Perform thorough evaluation including the temperature characteristics with an actual
application using the above capacitors to confirm no oscillation occurs.
 Selection of Regulator Block Input Capacitor (C_IN) and Output Capacitor (C_L)
The S-1740/1741 Series requires C_L between the VOUT pin and the VSS pin for regulator phase compensation.
The operation is stabilized by a ceramic capacitor with capacitance of 1.0 μF to 100 μF. When using an OS capacitor, a
tantalum capacitor or an aluminum electrolytic capacitor, the capacitance must also be 1.0 μF to 100 μF. However, an
oscillation may occur depending on the equivalent series resistance (ESR).
Moreover, the S-1740/1741 Series requires C_IN between the VIN pin and the VSS pin for a stable operation.
Generally, an oscillaiton may occur when a voltage regulator is used under the conditon that the impedance of the power
supply is high. Note that the output voltage transient characteristics vary depending on the capacitance of C_IN and C_L and
the value of ESR.
Caution Perform thorough evaluation including the temperature characteristics with an actual application to
select C_IN, C_L.
 Selection of Power Monitor Block Output Capacitor (C_PM)
The S-1740/1741 Series requires C_PM between the PMOUT pin and the VSS pin for power monitor phase compensation.
The operation is stabilized by a ceramic capacitor with capacitance of 100 nF to 220 nF. When using an OS capacitor, a
tantalum capacitor or an aluminum electrolytic capacitor, the capacitance must also be 100 nF to 220 nF. However, an
oscillation may occur depending on ESR.
Note that the output voltage transient characteristics vary depending on the capacitance of C_PM and the value of ESR.
Caution Perform thorough evaluation including the temperature characteristics with an actual application to
select C_PM.
13