LC89057W-VF4A-E Datasheet, PDF (46/59 Pages) Sanyo Semicon Device – Digital Audio Interface Transceiver

LC89057W-VF4A-E
______
CCB address: 0xE8; Command address: 8; Demodulation function: INT output contents setting
DI7
DI6
DI5
DI4
DI3
DI2
DI1
DI0
1
0
0
0
0
0
CAU
CAL
DI15
EMPF
DI14
SLIPO
DI13
PCRNW
DI12
UNPCM
DI11
CSRNW
DI10
FSCHG
DI9
INDET
DI8
ERROR
ERROR
RERR signal output setting
0: Don't output (initial value)
1: Output RERR pin status change
INDET
Input data detection output setting
0: Don't output (initial value)
1: Output input data pin status change
FSCHG
Setting of updated flag output of PLL lock frequency calculation result
0: Don't output (initial value)
1: Output updated flag of PLL lock frequency calculation result
CSRNW
Output setting for updated flag of first 48-bit channel status data
0: Don't output (initial value)
1: Output update flag of first 48-bit channel status data
UNPCM
Output setting for change flag of non-PCM data detection
0: Don't output (initial value)
____________
1: Output AUDIO pin status change
PCRNW
Output setting for updated flag of burst preamble Pc
0: Don't output (initial value)
1: Output updated flag of burst preamble Pc
SLIPO
Output setting of slip signal during slave operation
0: Don't output (initial value)
1: Output duplicate reading and a detection flag for missing of data output
EMPF
Output setting of emphasis detection flag
0: Don't output (initial value)
1: Output emphasis detection flag
• _{The channel status update flag compares the first 48 bits of data of the previous block with those of the current block.}
If these data are identical, it outputs a flag, considering the data has been updated.
• _{The burst preamble Pc update flag also compares the 16 bits of data of the previous block with those of the current}
data. If they are identical, an update flag is output.
No.7202-46/59