LC89057W-VF4A-E Datasheet, PDF (33/59 Pages) Sanyo Semicon Device – Digital Audio Interface Transceiver

LC89057W-VF4A-E
11.1.3 Validity flag input (VI)
• _{Validity flags can be input from RX5/VI by switching the contents of RX5/VI input by VISEL.}
• _{The timing of writing a validity flag is shown below. The validity flag can be also written with the microcontroller}
interface, but port settings have priority over the validity flag.
• _{Writing validity flags with the microcontroller interface is done using VMODE.}
RX5/VI
0
1
Table 11.1 RX5/V1 Input
Output Conditions
No error
Error
TLRCK
TBCK
VI
Internal latch signal
L1
R1
L2
R2
L3
V-L1
V-R1
V-L2
V-R2
V-L3
Figure 11.2 Validity Flag Input Timing
11.1.4 User data input (UI)
• _{User data can be input from RX6/UI by switching the contents of RX6/UI input by UISEL.}
• _{The timing of writing the user data is shown below.}
• _{It is also possible to write user data using the preamble B sync signal as the reference. Generation of the preamble B}
sync signal is configured in PBSEL[1:0] as in the case of the DIR function. After the setting, the signal is output from
CKST/PB.
TLRCK
TBCK
UI
Internal latch signal
U
U
U
U
U
Figure 11.3 User Data Input Timing
No.7202-33/59