K4T1G084QD Datasheet, PDF (27/27 Pages) Samsung semiconductor – 1Gb D-die DDR2 SDRAM Specification

K4T1G084QD
K4T1G164QD
DDR2 SDRAM
29. Input waveform timing with differential data strobe enabled MR[bit10]=0, is referenced from the input signal crossing at the V_IH(ac) level to the differen-
tial data strobe crosspoint for a rising signal, and from the input signal crossing at the V_IL(ac) level to the differential data strobe crosspoint for a falling
signal applied to the device under test.
30. Input waveform timing with differential data strobe enabled MR[bit10]=0, is referenced from the input signal crossing at the V_IH(dc) level to the differen-
tial data strobe crosspoint for a rising signal and V_IL(dc) to the differential data strobe crosspoint for a falling signal applied to the device under test.
DQS
DQS
tDS tDH
tDS tDH
V_DDQ
V_IH(ac) min
V_IH(dc) min
V_REF(dc)
V_IL(dc) max
V_IL(ac) max
V_SS
< Differential Input waveform timing >
31. Input waveform timing is referenced from the input signal crossing at the V_IH(ac) level for a rising signal and V_IL(ac) for a falling signal applied to the
device under test.
32. Input waveform timing is referenced from the input signal crossing at the V_IL(dc) level for a rising signal and V_IH(dc) for a falling signal applied to the
device under test.
CK
CK
tIS tIH
tIS tIH
V_DDQ
V_IH(ac) min
V_IH(dc) min
V_REF(dc)
V_IL(dc) max
V_IL(ac) max
V_SS
33. tWTR is at lease two clocks (2 * tCK) independent of operation frequency.
34. Input waveform timing with single-ended data strobe enabled MR[bit10] = 1, is referenced from the input signal crossing at the VIH(ac) level to the
single-ended data strobe crossing VIH/L(dc) at the start of its transition for a rising signal, and from the input signal crossing at the VIL(ac) level to the
single-ended data strobe crossing VIH/L(dc) at the start of its transition for a falling signal applied to the device under test. The DQS signal must be
monotonic between Vil(dc)max and Vih(dc)min.
35. Input waveform timing with single-ended data strobe enabled MR[bit10] = 1, is referenced from the input signal crossing at the VIH(dc) level to the
single-ended data strobe crossing VIH/L(ac) at the end of its transition for a rising signal, and from the input signal crossing at the VIL(dc) level to the
single-ended data strobe crossing VIH/L(ac) at the end of its transition for a falling signal applied to the device under test. The DQS signal must be
monotonic between Vil(dc)max and Vih(dc)min.
36. tCKEmin of 3 clocks means CKE must be registered on three consecutive positive clock edges. CKE must remain at the valid input level the entire
time it takes to achieve the 3 clocks of registeration. Thus, after any cKE transition, CKE may not transitioin from its valid level during the time period
of tIS + 2*tCK + tIH.
25 of 29
Rev. 1.0 March 2007