M16C6C_15 Datasheet, PDF (98/100 Pages) Renesas Technology Corp – RENESAS MCU

REVISION HISTORY
M16C/6C Group Datasheet
Rev.
2.00
2.10
Date
Feb 07, 2011
Jul 31, 2011
Description
Page
Summary
49 Table 29.5 A/D Conversion Characteristics (1/2):
Added the Measuring Condition of the Resolution row.
50 Table 5.6 A/D Conversion Characteristics (2/2): Added the note 5.
52
Table 5.9 CPU Clock When Operating Flash Memory (f_(BCLK)):
Added the Typ. value of the Low current consumption read mode.
52 Table 5.10 Flash Memory (Program ROM 1, 2) Electrical Characteristics:
• Added a condition to the Read voltage row.
• Modified note 1.
• Deleted the example stated in note 4.
53 Table 5.11 Flash Memory (Data Flash) Electrical Characteristics:
Changed “128 groups” to “256 groups” in note 4.
54
Table 5.12 Voltage Detector 0 Electrical Characteristics: Added the condition in the V_det0
row.
55 Table 5.15 Power-On Reset Circuit:
• Added the V_por1 and t_w(por) row.
• Deleted the Condition of t_rth row.
• Added the last line in note 1.
55 Figure 5.5 Power-On Reset Circuit Electrical Characteristics:
• Changed the signal name “0.1 V” to “V_por1”.
• Deleted note 2.
57 Table 5.17 40 MHz On-Chip Oscillator Electrical Characteristics:
Changed the Condition in the f_OCO40M row.
59
Table 5.20 Electrical Characteristics (2): Added “ZP, IDU, IDV, IDW” to the V_T+ - V_T- row.
60 Table 5.21 Electrical Characteristics (3):
Added the During flash memory program row and During flash memory erase row.
65, 83 5.2.2.5 and 5.3.2.5 Timer S Input: Added.
67, 85 5.2.2.8 and 5.3.2.8 Multi-master I²C-bus: Added.
68 Table 5.36 Memory Expansion Mode and Microprocessor Mode:
Changed RDY input setup time from 30.
68 to 75,
86 to 93
Table 5.36 to Table 5.39 and Table 5.56 to Table 5.59 Memory Expansion Mode and
Microprocessor Mode:
Deleted the following:
• HOLD input setup time
• HOLD input hold time
• HLDA output delay time
69, 87 Figure 5.16 and Figure 5.29 Timing Diagram:
Deleted lower figure (Common to wait state and no wait state settings).
77
Table 5.40 Electrical Characteristics (1): Added “ZP, IDU, IDV, IDW” to the V_T+ - V_T- row.
78 Table 5.41 Electrical Characteristics (2):
Added the During flash memory program row and During flash memory erase row.
86 Table 5.56 Memory Expansion Mode and Microprocessor Mode:
Changed RDY input setup time from 40.
Electrical Characteristics
Vcc = 5 V
61
Table 5.21 Electrical Characteristics (3): Changed the Measuring Condition column of 40
MHz on-chip oscillator for the 40 MHz on-chip oscillator mode in the I_CC.
Vcc = 3 V
79
Table 5.41 Electrical Characteristics (2): Changed the Measuring Condition column of 40
MHz on-chip oscillator for the 40 MHz on-chip oscillator mode in the I_CC.
All trademarks and registered trademarks are the property of their respective owners.
A-2