AN91162 Datasheet, PDF (33/43 Pages) Ramtron International Corporation – Creating a BLE Custom Profile

Testing with CySmart Mobile App
1. Download the CySmart mobile app on your BLE-
enabled phone. For iOS devices (iPhone 4S or later),
download the app from App Store. For Android
devices (Android 4.3 or later), download the app from
Play Store.
2. Start the app on your mobile. If Bluetooth on your
mobile is not enabled, the app will prompt you to
enable it, as shown in Figure 39.
Note The screenshots are for the CySmart Android
app. The look and feel of the CySmart iOS app may
differ slightly.
Figure 39. Enable Bluetooth on Mobile
Creating a BLE Custom Profile
4. Select the CY Custom BLE device. The connection
procedure should be initiated and device connected.
The screen after connection will display profile/service
pages that the connected device supports (Figure 41).
Figure 41. Service Page
5. If RGB LED icon is not displayed, Swipe left or right.
Select the RGB LED icon when it appears.
6. On the RGB LED GUI screen, the Color Gamut
(Figure 42) controls the value of Red, Green, and
Blue components whereas the linear slider controls
the intensity. Increase the intensity using slider and
then swipe on the Color Gamut to see the same color
being set on the BLE Pioneer Kit RGB LED.
Figure 42. RGB LED Color Control
3. After enabling Bluetooth, the device screen will be
displayed. Swipe down to list all the BLE devices
present in the vicinity, including the PSoC 4 BLE
Custom Service project “CY Custom BLE” (Figure
40).
Figure 40. BLE Devices Listed
www.cypress.com
7. To disconnect the device, tap on the Back button in
the app until you reach the Device Search page.
Document No. 001-91162 Rev. *A
33