AN91162 Datasheet, PDF (19/43 Pages) Ramtron International Corporation – Creating a BLE Custom Profile

Figure 24. PrISM Component Settings
Creating a BLE Custom Profile
3. Configure the PrISM_2 Component with identical settings. For this Component, only one output, pulse_den0, is used for
the third LED. The other output will not be connected.
4. Add the following Components to the input connections of both PrISM Components from the Component Catalog:
 A Logic High (1) Component on the enable input pins to enable the Component by default.
 Logic Low (0) Component on the kill and reset input pins to disable the hardware reset and kill options of the
Component. These two options are not needed in this project.
Figure 25. Logic High and Logic Low Components
5. Drag and drop a Clock Component from the System group on the Component Catalog, and configure it as shown in
Figure 26, and click OK:
 Rename the instance to PrISM_Clock.
www.cypress.com
Document No. 001-91162 Rev. *A
19