PISA11.CLASS2 Datasheet, PDF (2/19 Pages) PULS GmbH – PROTECTION MODULE 24V, 4 OUTPUTS

PISA11-Series
PISA11.CLASS2
PROTECTION MODULE 24V, 4 OUTPUTS
INDEX
Page
1. Intended Use .......................................................3
2. Product Description.............................................3
3. Installation Requirements...................................3
4. Input ....................................................................5
5. Outputs ................................................................5
6. Current Limitation and Shutdown Behavior......6
7. Connecting Capacitive Loads to the Outputs ....8
8. Output-OK Relay Contact ...................................9
9. ON/OFF and Reset Signal Input ..........................9
10. Synchronization of Multiple PISA Modules .......9
11. Functional Diagram...........................................10
12. Back-feeding Loads ...........................................10
13. Power Losses......................................................11
Page
14. Reliability .......................................................... 11
15. Front Side and User Elements .......................... 12
16. Terminals and Wiring....................................... 13
17. EMC ................................................................... 14
18. Environment ..................................................... 15
19. Protection Features .......................................... 16
20. Dielectric Strength............................................ 16
21. Approvals .......................................................... 17
22. Read-out of the Software Revision Level ........ 18
23. Physical Dimensions and Weight ..................... 19
24. Accessory........................................................... 19
24.1. ZM3.WALL Wall Mounting Bracket .......19
The information presented in this document is believed to be accurate and reliable and may change without notice.
The housing is patent by PULS (US patent No US D442,923S).
No part of this document may be reproduced or utilized in any form without permission in writing from the publisher
(PULS GmbH). This also applies to all kinds of electronic publishing.
TERMINOLOGY AND ABREVIATIONS
DC 24V
24Vdc
A figure displayed with the AC or DC before the value represents a nominal voltage with
standard tolerances (usually ±15%) included.
E.g.: DC 12V describes a 12V battery disregarding whether it is full (13.7V) or flat (10V)
A figure with the unit (Vdc) at the end is a momentary figure without any additional
tolerances included.
May 2014 / Rev. 1.7 DS-PISA11.CLASS2 - data sheet -
All parameters are specified at 24Vdc input, 25°C ambient temperature and a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone [phone] Germany
2/19