MN101EFA6 Datasheet, PDF (24/33 Pages) Panasonic Semiconductor – 8-bit Single-chip Microcontroller

1.5.3 DC Characteristics
MN101EFA6/A5/A1/A0 Series
8-bit Single-chip Microcontroller
PubNo. 216A6-012E
C. DC Characteristics
V_SS = 0 V
Ta = -40 C to +85 C
Parameter
Symbol
Conditions
Rating
Unit
MIN TYP MAX
Power supply current *8
C1
I_DD1
C2 _{Power supply} I_DD2
current during
C3 ^operation
I_DD3
C4
I_DD4
Power supply
C5 current during I_DD5
STOP mode
fosc=10 MHz [Double-speed mode: fs=fosc]
V_DD5=5 V (PLL is not used) *9
fosc=10 MHz [Multiplied by 2, Divided by 2: fs=fosc]
V_DD5=5 V (PLL is used) *9
fosc=10 MHz [Multiplied by 2: fs=20 MHz]
V_DD5=5 V (PLL is used) *9
frc=16 MHz [Double-speed mode: fs=16 MHz]
V_DD5=5 V (PLL is used) *9
V_DD5=5 V
Ta = -40 C to +85 C
5 14
6 18
mA
9 20
6 15
145 245 A
*8 Measured without loading (pull-up and pull-down resistors are not connected.)
To measure the power supply current during operation I_DD1 to I_DD4;
1. Set all I/O pins to input mode,
2. Set the CPU mode to “NORMAL mode”,
3. Fix pin MMOD to V_SS level and input pins to V_DD5 level
4. Input the rectangular wave of 10 MHz(4 MHz) with amplitude of V_DD5 and V_SS, from pin OSC1.
To measure the power supply current during STOP mode I_DD5;
1. Set the CPU mode to “STOP mode”,
2. Fix pin MMOD to V_SS level and input pin to V_DD5 level
3. Open pin OSC1.
*9 When ROMHND of HANDSHAKE register is set to “1”
Publication date: November 2014