LC75886PW Datasheet, PDF (19/36 Pages) ON Semiconductor – 1/4 and 1/3-Duty LCD Display Driver

LC75886PW
Key input
(KS6 line)
Key scan
CE
DI
615T[s]
Serial data transfer Serial data transfer
(KSC=0)
(KSC=0)
615T[s]
Key
Serial data transfer
address(43H)
(KSC=0)
Key
address(43H)
1
1
T= _fOSC = _fCK
DO
Key data read request
Key data read
Key data read
Key data read request
4. Normal/sleep mode, when key scan operations are disabled
(1) The KS1 to KS6 pins are set to high or low level by the S0 and S1 bits in the control data.
(2) No key scan operation is performed, whichever key is pressed.
(3) If the key scan disabled state (KSC=1 in the control data) is set during a key scan, the key scan is stopped.
(4) If the key scan disabled state (KSC=1 in the control data) is set when a key data read request (a low level on DO) is
output to the controller, all the key data is set to 0 and the key data read request is cleared (DO is set high).
Note that DO, being an open-drain output, requires a pull-up resister (between 1 to 10kΩ).
(5) The key scan disabled state is cleared by setting KSC in the control data to 0.
Key input 1
Key input 2
Key scan
CE
Serial data transfer Serial data transfer
(KSC=0)
(KSC=1)
DI
615T[s]
Serial data transfer
(KSC=0)
Serial data transfer
(KSC=1)
615T[s]
Serial data transfer
(KSC=0)
Key
address(43H)
DO
Key data read request
Key data read
Key data read request
1
1
T= _fOSC = _fCK
Multiple Key Presses
Although the LC75886PW is capable of key scanning without inserting diodes for dual key presses, triple key presses
on the KI1 to KI5 input pin lines, or multiple key presses on the KS1 to KS6 output pin lines, multiple presses other
than these cases may result in keys that were not pressed recognized as having been pressed. Therefore, a diode must be
inserted in series with each key. Applications that do not recognize multiple key presses of three or more keys should
check the key data for three or more 1 bits and ignore such data.
No.A1391-19/36