Y92S-27 Datasheet, PDF (14/61 Pages) Omron Electronics LLC – DIN 48 x 48-mm Multifunctional Timer Series

H3CR-A
Operating
mode
D:
Signal OFF-
delay
Power
Start
Timing chart
Basic operation
Power
E:
Interval
Reset
Output relay (NC)
Output relay (NO)
(Output indicator)
Power indicator
Power
Start
Reset
Output relay (NC)
Output relay (NO)
(Output indicator)
Power indicator
G:
Signal ON/
OFF-delay
Power
Start
Reset
Output relay (NC)
Output relay (NO)
(Output indicator)
Power indicator
J:
One-shot
output
Power
Start
Reset
Output relay (NC)
Output relay (NO)
(Output indicator)
Power indicator
1±0.6 s
(Fixed)
1±0.6 s
(Fixed)
Start
(See note)
t
Output
Note: Start input is valid and
retriggerable while the
Timer is in operation.
Basic operation
Power
Start
(See note)
t
Output
Note: Start input is valid and
retriggerable while the
Timer is in operation.
(Previous start input
will be cancelled.)
Basic operation
Power
Start
(See note)
t
tt
t
Output
Note:
Start input is valid and
retriggerable while the Timer
is in operation.
Basic operation
Power
Start
(See note)
t
1±0.6 s
Output
(Fixed)
Note: Start input is valid and
retriggerable while the
Timer is in operation.
(Previous start input will
be cancelled.)
Gate Signal Input (This timing chart indicates the gate input in operating mode A (ON-delay operation).)
t1
t2
Power
ON
OFF
Start ON
OFF
Gate ON
OFF
Reset ON
OFF
Output ON
relay OFF
Note: 1. Allow at least 0.1 s for the Timer reset time if the power
supply is reset due to an interruption in the power supply.
2. The minimum input pulse width (for start, reset) is 0.05 s.
3. The letter "t" in the timing charts indicates the set time, and
"t-a" means that the period is less than the set time.
(t - a < 1)
4. In J Mode, there will be only one output even if the start input is
longer than the set time.
5. H3CR-AP model incorporates start input only.
6. Model H3CR-AS only has operation equivalent to time-limit
contact: NO.
7. When the setting dial is turned all the way past 0 for
intantaneous output, "t" (set time) in the above time chart is
0-sec operation.
Note: The set time is the sum of t1 and t2.
Start and reset are also both enabled when the gate signal is ON.
14