S8JXG05012CD Datasheet, PDF (14/59 Pages) Omron Electronics LLC – Switch Mode Power Supply

S8JX
Construction and Nomenclature
Nomenclature
15-/35-/50-/100-/150-W Models
D
D
E
E
+V
A
A
−V
C
C
AC (L)
B
B
AC (N)
Note: The S8JX-G05024CD is
shown above.
No.
Name
Function
1
DC Output
Terminals (−V), (+V)
Connect the load lines to these terminals.
+V
−V
2
AC Input Terminals
(L), (N)
Connect the input lines to these terminals. *1
AC (L)
AC (N)
3
Protective Earth
Terminal (PE) (
) ^{Connect the ground line to these terminals. *2}
4
Output Voltage
Adjuster (V. ADJ)
It is possible to increase or decrease the output
voltage.
5
Output Indicator
(DC ON: Green)
Lights green while a direct current (DC) output is ON.
F
Bottom
Switches the internal circuits according to the input
6
Input voltage switch
voltage.
"115V": 100 to 120 VAC
"230V": 200 to 240 VAC
100 to 120 VAC 200 to 240 VAC _{*1. The fuse is located on the (L) side. It is NOT user-replaceable. For a DC}
Note: The S8JX-G15005C is shown ^{power input, connect the low side to the positive (+) terminal.}
above.
*2. This is the protective earth terminal specified in the safety standards.
Always ground this terminal.
300-W 5V, 12V Model
300-W Model
+V
+V
−V
−V
Bottom
AC(L)
AC(N)
Note: The S8JX-G30005C is shown above.
300-W 24V, 48V Model
E
F
A
+V
+V
−V
−V
Bottom
AC (L)
B
AC (N)
D
C
No.
Name
Function
1
DC Output
Terminals (+V), (−V)
Connect the load lines to these terminals.
2
AC Input Terminals
(L), (N)
Connect the input lines to these terminals. *1
3
Protective Earth
Terminal (PE) (
) ^{Connect the ground line to these terminals. *2}
4
Input Voltage
Selector Terminals
Short-circuit the terminals if the input is 100 to 120
VAC and open the terminals if the input is 200 to 240
VAC.
5
Output Indicator
(DC ON: Green)
Lights green while a direct current (DC) output is ON.
6
Output Voltage
Adjuster (V. ADJ)
It is possible to increase or decrease the output
voltage.
Protection-ON
7 Alarm Indicator
(ALM: Red)
The red indicator will be lit if the overvoltage or
overheat protection circuit is triggered. This indicator
will also be lit when overload is detected. *3
8
Selector of Parallel Set the selector to PARALLEL if the Units are in
Operation
parallel operation.
*1. The fuse is located on the (L) side. It is NOT user-replaceable.
*2. This is the protective earth terminal specified in the safety standards.
Always ground this terminal.
*3. This is not applicable to 24-V and 48-V models.
Note: The S8JX-G30024C is shown above.
H
14