SA56004X Datasheet, PDF (4/36 Pages) NXP Semiconductors – 1 Degrees Celcious accurate, SMBus-compatible, 8-pin, remote/local digital temperature sensor with over temperature alarms

NXP Semiconductors
6. Pinning information
6.1 Pinning
SA56004X
Digital temperature sensor with overtemperature alarms
V_DD 1
D+ 2
D− 3
SA56004XD
8 SCLK
7 SDATA
6 ALERT
T_CRIT 4
5 GND
002aad198
Fig 2. Pin configuration for SO8
V_DD 1
D+ 2
D− 3
T_CRIT 4
SA56004XDP
8 SCLK
7 SDATA
6 ALERT
5 GND
002aad199
Fig 3. Pin configuration for TSSOP8
terminal 1
index area
V_DD 1
8 SCLK
D+ 2
D− 3
SA56004XTK
7 SDATA
6 ALERT
T_CRIT 4
5 GND
002aad200
Transparent top view
Fig 4. Pin configuration for HVSON8
6.2 Pin description
Table 3.
Symbol
V_DD
D+
D−
T_CRIT
GND
ALERT
SDATA
SCLK
Pin description
Pin Description
1
Positive supply voltage. DC voltage from 3.0 V to 5.5 V.
2
Diode current source (anode).
3
Diode sink current (cathode).
4
T_CRIT alarm is open-drain, active LOW output which requires an external
pull-up resistor. It functions as a system interrupt or power shutdown.
5
Power supply ground.
6
ALERT alarm is an open-drain, active LOW output which requires an
external pull-up resistor. It functions as an interrupt indicating that the
temperature of the on-chip or remote diode is above or below programmed
overtemperature or undertemperature thresholds.
7
SMBus/I²C-bus bidirectional data line. This is an open-drain output which
requires an external pull-up resistor.
8
SMBus/I²C-bus clock input which requires an external pull-up resistor.
SA56004X_5
Product data sheet
Rev. 05 — 22 May 2008
© NXP B.V. 2008. All rights reserved.
4 of 36