TDA8262HN Datasheet, PDF (27/30 Pages) NXP Semiconductors – Fully integrated satellite tuner

Philips Semiconductors
TDA8262HN
Fully integrated satellite tuner
• Use a double-wave soldering method comprising a turbulent wave with high upward
pressure followed by a smooth laminar wave.
• For packages with leads on two sides and a pitch (e):
– larger than or equal to 1.27 mm, the footprint longitudinal axis is preferred to be
parallel to the transport direction of the printed-circuit board;
– smaller than 1.27 mm, the footprint longitudinal axis must be parallel to the
transport direction of the printed-circuit board.
The footprint must incorporate solder thieves at the downstream end.
• For packages with leads on four sides, the footprint must be placed at a 45° angle to
the transport direction of the printed-circuit board. The footprint must incorporate
solder thieves downstream and at the side corners.
During placement and before soldering, the package must be fixed with a droplet of
adhesive. The adhesive can be applied by screen printing, pin transfer or syringe
dispensing. The package can be soldered after the adhesive is cured.
Typical dwell time of the leads in the wave ranges from 3 seconds to 4 seconds at 250 °C
or 265 °C, depending on solder material applied, SnPb or Pb-free respectively.
A mildly-activated flux will eliminate the need for removal of corrosive residues in most
applications.
19.4 Manual soldering
Fix the component by first soldering two diagonally-opposite end leads. Use a low voltage
(24 V or less) soldering iron applied to the flat part of the lead. Contact time must be
limited to 10 seconds at up to 300 °C.
When using a dedicated tool, all other leads can be soldered in one operation within
2 seconds to 5 seconds between 270 °C and 320 °C.
19.5 Package related soldering information
Table 40: Suitability of surface mount IC packages for wave and reflow soldering methods
Package ^[1]
Soldering method
Wave
Reflow ^[2]
BGA, HTSSON..T ^[3], LBGA, LFBGA, SQFP,
SSOP..T ^[3], TFBGA, VFBGA, XSON
not suitable
suitable
DHVQFN, HBCC, HBGA, HLQFP, HSO, HSOP,
HSQFP, HSSON, HTQFP, HTSSOP, HVQFN,
HVSON, SMS
not suitable ^[4]
suitable
PLCC ^[5], SO, SOJ
suitable
suitable
LQFP, QFP, TQFP
not recommended ^{[5] [6]}
suitable
SSOP, TSSOP, VSO, VSSOP
not recommended ^[7]
suitable
CWQCCN..L ^[8], PMFP ^[9], WQCCN..L ^[8]
not suitable
not suitable
[1] For more detailed information on the BGA packages refer to the (LF)BGA Application Note (AN01026);
order a copy from your Philips Semiconductors sales office.
9397 750 13194
Product data sheet
Rev. 01 — 14 December 2004
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
27 of 30