|
TDA8595 Datasheet, PDF (13/50 Pages) NXP Semiconductors – I2C-bus controlled 4 ´ 45 W power amplifier | |||
|
◁ |
NXP Semiconductors
TDA8595
I2C-bus controlled 4 à 45 W power ampliï¬er
When the SVR capacitor has discharged, the ampliï¬er starts up again if the VP voltage is
above the low VP mute threshold, typically 7.5 V. Below the low VP mute threshold, the
outputs of the ampliï¬er remain low. In I2C-bus mode, a supply voltage drop below VP(reset),
typically 5 V, results in setting bit DB2[D7]. The ampliï¬ers will not start-up but wait for an
I2C-bus command to start-up.
The ampliï¬er prevents audio pops during engine start. To prevent pops on the output
caused by the application during an engine start (for instance tuner regulator out of
regulation), the STB pin can be made zero when an engine start is detected. The STB pin
activates the fast mute and disturbances at the ampliï¬er inputs are suppressed.
V
(V)
VP
14
VSVR
8.4
7
VO (2)
Vhr (1)
(1) Headroom voltage Vhr = VP â VO.
(2) Steady state output voltage VO = VSVR â 1.4 V.
(3) Headroom protection threshold = VO + 1.6 V.
Fig 8. Low headroom protection
1.6 V
headroom protection
threshold (3)
t (s)
001aad172
TDA8595_2
Product data sheet
Rev. 02 â 21 November 2007
© NXP B.V. 2007. All rights reserved.
13 of 50
|
▷ |