LMH0031 Datasheet, PDF (8/31 Pages) National Semiconductor (TI) – SMPTE 292M/259M Digital Video Deserializer Descrambler with Video and Ancillary Data FIFOs

AC Electrical Characteristics (Continued)
Note 2: Current flow into device pins is defined as positive. Current flow out of device pins is defined as negative. All voltages are referenced to V_SSIO = V_SSD =
V_SSSI = 0V.
Note 3: Typical values are stated for V_DDIO = V_DDSI = +3.3V, V_DDD = V_DDPLL = +2.5V and T_A = +25˚C.
Note 4: Spec. is guaranteed by design.
Note 5: Measured from rising-edge of first SDI cycle until Lock Detect bit goes high (true). Lock time includes CDR phase acquisition time plus PLL lock time.
Note 6: V_OHV and V_OLP are measured with respect to reference ground. V_OLP is the peak output LOW voltage or ground bounce that may occur under dynamic
simultaneous output switching conditions. V_OHV is the lowest output HIGH voltage or output droop that may occur under dynamic simultaneous output switching
conditions.
Note 7: When used to clock control data into or from the LMH0031, the duty cycle restriction does not apply.
Note 8: I_IH includes static current required by input pull-down devices.
Note 9: Required Input Conditions are the electrical signal conditions or component values which shall be supplied by the circuit in which this device is used in order
for it to produce the specified DC and AC electrical output characteristics.
Note 10: Functional and certain other parametric tests utilize a LMH0030 as the input source to the SDI inputs of the LMH0031. The LMH0030 is DC coupled to
the inputs of the LMH0031. Typical V_IN = 800 mV, V_CM = 2.9 V.
Test Loads
20179604
www.national.com
8