PRF18BA471QB5RB Datasheet, PDF (93/104 Pages) Murata Manufacturing Co., Ltd. – POSISTOR for Circuit Protection

!Note • Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
R90E.pdf
Sep.24,2012
Continued from the preceding page.
(2) Reflow soldering conditions
The following figure and table show our recommended
reflow profile.
(a) Insufficient preheating may cause a crack on
ceramic body. The temperature difference between
preheat and peak should be control within 100°C to
prevent this.
(b) The excessive soldering conditions may cause
dissolution of metallization or deterioration of
solder-wetting on the external electrode.
(c) Rapid cooling by dipping in solvent or by other
means is not recommended.
(d) Please evaluate it on your condition if you will do
mounting using not applying condition to the
above-mentioned.
!Caution/Notice
Temp. (°C)
270°C
250°C
220°C
Limit Profile
180°C
150°C
Standard Profile
90±30s
30 to 60s
90s
Time (s)
Preheat
Soldering Time (U220°C)
Peak Temp.
Reflow Cycle
Standard Profile Limit Profile
150 to 180°C, 90±30s
30 to 60s
90s
250°C
270°C
Max. 2 times
Max. 2 times
(3) There may be a risk of unexpected failures
(tombstone, insufficient solder-wetting, etc.) in the
mounting process, caused by the mounting conditions.
Please make sure that this product is correctly
mounted under specified mounting conditions.
91