MAX11358B Datasheet, PDF (42/70 Pages) Maxim Integrated Products – 16-Bit Data-Acquisition System with ADC, DAC, UPIOs, RTC, Voltage Monitors, and Temp Sensor

16-Bit Data-Acquisition System with ADC, DAC,
UPIOs, RTC, Voltage Monitors, and Temp Sensor
REF_SDC Register (Power-On State: 0000 0000)
MSB
REFV1
REFV0
AOFF
AON
The REF_SDC register contains bits to control the refer-
ence voltage and signal-detect comparator.
REFV<1:0>: Reference buffer voltage gain and enable
bits. Enables the output buffer, and sets the gain and
the voltage at the REF pin as shown in Table 10. Power-
on state is off to enable an external reference to drive
the REF pin without contention.
AOFF: ADC and DAC/op-amp power-off bit. This bit pro-
vides a method for turning off several analog functions
with a single write. Setting AOFF = 1 deasserts the
ADCE in the ADC register and the DAE, DBE, and OP1E
bits in the DACA_OP and DACB_OP registers, powering
down these analog blocks. Setting AOFF = 0 has no
effect. The AON bit has priority when both AON and
AOFF bits are asserted.
Most of the analog functions can be disabled with a
single write to the REF_SDC register by using AOFF,
REFV<1:0>, and SDCE.
SDCE
TSEL2
TSEL1
LSB
TSEL0
AON: ADC and DAC/op-amp power-on bit. This bit pro-
vides a method of turning on several analog functions
with a single write. Setting AON = 1 asserts the ADCE
bit in the ADC register and DAE, DBE, and OP1E bits in
the DACA_OP and DACB_OP register, powering up
these blocks. Setting AON = 0 has no effect. The AON
bit has priority when both AON and AOFF bits are
asserted.
Most of the analog functions can be enabled with a sin-
gle write to the REF_SDC register using AON,
REFV<1:0>, and SDCE.
SDCE: Signal-detect comparator power-enable bit. Set
SDCE = 1 to power up the signal-detect comparator,
and set SDCE = 0 to power down the signal-detect
comparator. The ADCE bit in the ADC register must be
set to 1 to use the signal-detect comparator.
TSEL<2:0>: Threshold-select bits. These bits select the
threshold for the signal-detect comparator as shown in
Table 11.
Table 10. Setting the Reference Output
Voltage
REFERENCE
BUFFER GAIN
(V/V)
REF OUTPUT
VOLTAGE (V)
REFV1
REFV0
Off (High
Disabled
Impedance
0
0
at REF)
1.0
1.638
2.0
1.25
2.048
2.5
0
1
1
0
1
1
Table 11. Setting the Signal-Detect
Comparator Threshold
NOMINAL
THRESHOLD (mV)
TSEL2
TSEL1
TSEL0
0
0
X
X
50
1
0
0
100
1
0
1
150
1
1
0
200
1
1
1
X = Don’t care.
42 ______________________________________________________________________________________