705-5100-121 Datasheet, PDF (19/56 Pages) Magnetrol International, Inc. – GuidedWave Radar Level Transmitter

y
x
z
x
3.4.5 Installing the Transmitter
The transmitter can be ordered for installation as an
Integral or Remote configuration.
3.4.5.1 Integral Mount
x Remove the protective plastic cap from the top of the
probe. Put the cap in a safe place in case the transmitter has
to be removed later.
y Place the transmitter on the probe. Be careful not to bend
{
or dirty the gold, high frequency (male) connector.
z Align the universal connection at the base of the transmitter
housing with the top of the probe. Hand tighten the
|
connection.
{ Rotate the transmitter to face the most convenient direction
for wiring, configuration, and viewing.
| When the transmitter is facing the desired direction, use a
1¹â„2" (38 mm) wrench to tighten the universal connection on
the transmitter to 15 ft-lbs. A torque wrench is highly rec-
ommended. This is a critical connection. DO NOT LEAVE
HAND TIGHT.
3.4.5.2 Remote Mount
x Mount the transmitter/remote bracket as an assembly
within 33" (84 cm) of the probe. DO NOT REMOVE
TRANSMITTER FROM BRACKET.
y Remove the protective plastic cap from the top of the probe.
Put the cap in a safe place in case the transmitter has to be
removed later.
z Align the universal connection at the end of the remote
assembly with the top of the probe. Using a 1¹â„2" (38 mm)
wrench, tighten the universal connection on the transmitter
to 15 ft-lbs. A torque wrench is highly recommended. This is
a critical connection. DO NOT LEAVE HAND TIGHT.
z
y
57-640 Eclipse Guided Wave Radar Transmitter - FOUNDATION fieldbus^™
19