408-2353 Datasheet, PDF (8/12 Pages) Tyco Electronics – Crimping Die Assemblies for COPALUM Terminals and Splices and HF- 30 Pin and Socket Contacts

Die Assemblies for COPALUM Terminals and Splices and HF- 30 Pin and Socket Contacts
HF- 30 Pin and Socket Contacts
ACCEPT
1
6
408- 2353
3
Top View
Cutout for Housing Latch
1
Cutout for Housing Latch
Bottom View
Housing Stop
7
Bottom View
3
Top View
Cutout for Housing Latch
1 ^{Crimps centered. Crimp may be slightly off center BUT}
NOT OFF END OF WIRE BARREL.
3 ^{Insulation does not enter wire barrel. No nicked,}
missing, or broken wire strands.
6
Crimp die embossment, and wire size agree
with table in Figure 2. The verification of the
correct terminal dash number used with proper
crimp die and wire size must be done prior to
crimping of contacts. See Paragraph 3.5.1.
7 ^{Crimp die embossment, and wire size agree}
with table in Figure 2. The verification of the
correct terminal dash number used with proper
crimp die and wire size must be done prior to
crimping of contacts. See Paragraph 3.5.1.
Cutout for Housing Latch
Figure 5B
(Crimp Inspection Criteria for HF--30 Pin and Socket Contacts)
8 of 12
Tyco Electronics Corporation
Rev B