408-2353 Datasheet, PDF (11/12 Pages) Tyco Electronics – Crimping Die Assemblies for COPALUM Terminals and Splices and HF- 30 Pin and Socket Contacts

Die Assemblies for COPALUM Terminals and Splices and HF- 30 Pin and Socket Contacts
408- 2353
Inspection of Bar Crimp Closure
Detail A
Inspection of Rectangular Crimp Closure
Left Die
Closure
Detail B
Right Die
Closure
Gage Dimension:
42.27 [1.664] for 8- 3/0 Sizes
74.3 [2.925] for 4/0- 500 MCM Sizes
Radius of
Bar Crimp
“GO” Gage Must Pass Completely
Through the Die Closure
“GO” Gage Must Enter
to Radius of Bar Crimp
“NO- GO” Gage May Enter Partially, but Must
Not Pass Completely Through the Die Closure
“NO- GO” Gage May Enter Partially, but
Must Not Enter to Radius of Bar Crimp
6. REPAIR/REPLACEMENT
Figure 8
7. REVISION SUMMARY
Replaceable parts are listed in Figure 9. Parts other
than those listed in Figure 9 should be replaced by
Tyco Electronics to ensure quality and reliability of the
tool. Order replacement parts through your Tyco
Electronics Representative, or call 1--800--526--5142,
or send a facsimile of your purchase order to
1--717--986--7605, or write to:
CUSTOMER SERVICE (38--35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105--3608
For tool repair service, please contact an Tyco
Electronics Representative at 1--800--526--5136.
S Updated document to corporate requirements
S Added new part number 68037--1 to tables in
Figures 1, 2, 7, and 9
S Added, deleted, or changed text in Section 2,
Paragraphs 3.1.1, 3.1.2 CAUTION, 3.2
DANGER, 3.2.1, 3.2.2, and SubHeadings 3.2,
3.3, and 3.4
S Deleted old and added new artwork to Figure 2
S Added new Paragraph 3.5.1 and renumbered
S Added new Figure 4 and renumbered
S Added new callouts to Figures 1, 2B, 3, and
deleted callout and added text to Figure 5B
S Combined Figures 6 and 7 and renumbered
Rev B
Tyco Electronics Corporation
11 of 12