408-2353 Datasheet, PDF (4/12 Pages) Tyco Electronics – Crimping Die Assemblies for COPALUM Terminals and Splices and HF- 30 Pin and Socket Contacts

Die Assemblies for COPALUM Terminals and Splices and HF- 30 Pin and Socket Contacts
Center
Splice in
Die
Detail C
COPALUM
Parallel Splice
Ends of Wires Must be
Flush with or Extend
Beyond Ends of Splice
408- 2353
Hydraulic Crimp Head
Stationary Die (Nest)
Detail D
HF- 30 Contact
End of Barrel Flush
with Edge of Die
Same Criteria Applies
to Pin Contact
Pin Contact
Assembly HF- 30
Socket Contact
Assembly HF- 30
Moving Die
(Indenter)
Wire inserted fully into contact
until insulation bottoms on edge
of contact. No wire strands
should be visible.
Detail E
HF- 30 Contact Location
Housing Stop on
Bottom
4 of 12
Stationary Die (Nest)
Flat Planar Surface
of Crimp Die Nest
Middle Plane of Contact
Pin Contact
Assembly
HF- 30
Figure 3 (end)
Contact Location: The middle plane
of contact should be parallel to the
planar surface of the crimp die nest.
This will prevent twist in the crimp
relative to the planar mating surface
of the contact. This applies to both
pin and socket contacts.
Tyco Electronics Corporation
Rev B