108-60034 Datasheet, PDF (6/7 Pages) Tyco Electronics – AMP Connector, USB Consortium, Plug & Receptacle Lead Free Version

connectors. A minimum of 30 contacts shall be selected and identified for each test group.
Unless otherwise specified, these contacts shall be used for all measurements.
B. Test Sequence
Qualification inspection shall be verified testing samples as specified in Figure 2.
4.2 Requalification Testing
If changes significantly affecting form, fit or function is made to be product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original
testing sequence as determined by development/product, quality and reliability engineering.
4.3 Acceptance
Acceptance is based on verification that the product meets requirement of Figure 1.Failures attributed
to equipment, test setup or operator deficiencies shall not disqualify the product. When product failure
occurs, corrective action shall be taken and samples resubmitted for qualification. Testing to confirm
corrective action is required before resubmitted.
4.4 Quality Conformance Inspection
Applicable AMP quality inspection plan will specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
ASHL-0005- ES REV A
Tyco Electronics
AMP Shanghai Ltd
PAGE NO
6
108-60034
REV LOC
O _ES