108-60034 Datasheet, PDF (3/7 Pages) Tyco Electronics – AMP Connector, USB Consortium, Plug & Receptacle Lead Free Version

3.5 Test Requirements and Procedures Summary:
Para.
Test Items
3.5.1 Examination of Product
3.5.2 Termination Resistance
Requirements
Procedures
Meets requirements of product drawing Visually, dimensionally and
and AMP Spec 114-40054.
functionally inspected per applicable
inspection plan
Electrical Requirements
R=10 mΩ Max.
AMP Spec 109-6-6
Subject mated contact assembled in
housing to 20 mv maximum open
circuit at 100 ma maximum
See figure 3
3.5.3 Insulation Resistance
1000 MΩ Min.
AMP Spec 109-28-4
Test between the adjacent contacts
of mating and unmating samples
3.5.4 Dielectric Withstanding
voltage
750 vac at sea level
1 minute hold with no breakdown
or flashover
AMP Spec 109-29-1
Test between the adjacent contacts
of mating and unmating samples
3.5.5 Capacitance
2 picofarads maximum
AMP Spec 109-47
Test between the adjacent contacts
of unmating samples at 1KHZ
3.5.6 Vibration Random
3.5.7 Physical Shock
3.5.8 Mating Force
Mechanical Requirements
No electrical discontinuities greater
than 1 microsecond shall occur.
See Note
No electrical discontinuity greater than
1 microsecond shall occur.
See Note
AMP Spec 109-21-5
Subject mated connectors to 5.35
G’s rms .15 minutes in each of 3
mutually perpendicular planes
See Figure 4
AMP Spec 109-26-1
Except 30 G’s
Subject mated connectors to 30 G’s
half-sine shock pulses of 11
millisecond duration; 3 shocks in
each direction applied along the 3
mutually perpendicular planes, total
18 shocks;
See figure 4
35 N maximum
AMP Spec 109-42
Condition A
Measure force necessary to mate
samples at maximum rate of 12.5
mm a minute.
ASHL-0005- ES REV A
Tyco Electronics
AMP Shanghai Ltd
PAGE NO
3
108-60034
REV LOC
O _ES