BTM510 Datasheet, PDF (22/23 Pages) Vishay Siliconix – Metallized Polyester Film Capacitors MKT Radial Potted Type

BTM510/511 Multimedia Module
Datasheet
8 BLUETOOTH SIG QUALIFICATION
The BTM510 and BTM511 modules are listed on the Bluetooth SIG website as qualified End Products.
Design
Name
BTM510,
BTM511
Owner
Laird
Declaration
ID
Link to listing on the SIG website
D023160 https://www.bluetooth.org/tpg/QLI_viewQDL.cfm?qid=23160
It is a mandatory requirement of the Bluetooth Special Interest Group (SIG) that every product implementing
Bluetooth technology has a Declaration ID. Every Bluetooth design is required to go through the qualification
process, even when referencing a Bluetooth Design that already has its own Declaration ID. The Qualification
Process requires each company to registered as a member of the Bluetooth SIG – www.bluetooth.org
The following link provides a link to the Bluetooth Registration page:
https://www.bluetooth.org/login/register/
For each Bluetooth Design it is necessary to purchase a Declaration ID. This can be done before starting the new
qualification, either through invoicing or credit card payment. The fees for the Declaration ID will depend on
your membership status, please refer to the following webpage:
https://www.bluetooth.org/en-us/test-qualification/qualification-overview/fees
For a detailed procedure of how to obtain a new Declaration ID for your design, please refer to the following SIG
document:
https://www.bluetooth.org/DocMan/handlers/DownloadDoc.ashx?doc_id=283698&vId=317486
To start the listing, go to: https://www.bluetooth.org/tpg/QLI_SDoc.cfm.
In step 1, select the option, Reference a Qualified Design and enter 16227 in the End Product table entry. You
can then select your pre-paid Declaration ID from the drop down menu or go to the Purchase Declaration ID
page, (please note that unless the Declaration ID is pre-paid or purchased with a credit card, it will not be
possible to proceed until the SIG invoice is paid.
Once all the relevant sections of step 1 are finished, complete steps 2, 3, and 4 as described in the help
document. Your new Design will be listed on the SIG website and you can print your Certificate and DoC.
For further information please refer to the following training material:
https://www.bluetooth.org/en-us/test-qualification/qualification-overview/listing-process-updates
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/ramp
22
© Copyright 2017 Laird. All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]