BTM510 Datasheet, PDF (12/23 Pages) Vishay Siliconix – Metallized Polyester Film Capacitors MKT Radial Potted Type

BTM510/511 Multimedia Module
Datasheet
use wording such as the following: “Contains Transmitter Module FCC ID: PI4510B” or “Contains FCC ID:
PI4510B.” Any similar wording that expresses the same meaning may be used.
3.2 BTM511 FCC and Industry Canada Statements
The user manual must show the following statements:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
To comply with the FCC RF exposure compliance requirements, this device and its antenna must not be co-
located or operating to conjunction with any other antenna or transmitter.
3.2.1 Considerations for OEM Integration
To inherit the modular approval, the antennas for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any
other antenna or transmitter.
Co-location with other radio transmitting devices operating concurrently in the same band requires additional
testing and certification.
Designers should note the distinction that the FCC makes regarding portable and mobile devices. Mobile devices
are defined as products that are not used closer than 20cm to the human body, whereas portable devices can be
used closer that 20cm to the body. A device may be used in portable exposure conditions with no restrictions on
host platforms when the averaged output power is less than the low power threshold for an uncontrolled
environment ≤ 60/f (GHz) i.e. 25 mW for a 2.4 Ghz device. The Maximum Power Exposure for the BTM511 has
been evaluated and found to comply with the low power threshold for an uncontrolled environment.
Refer to FCC document KDB 447498 for more information on RF exposure procedures and equipment
authorization policies for mobile and portable devices.
3.2.2 FCC Labelling requirement
If the FCC ID is not visible when the module is installed inside another device, then the outside of the device into
which the module is installed must also display a label referring to the enclosed module. This exterior label can
use wording such as the following: “Contains Transmitter Module FCC ID: PI4511B” or “Contains FCC ID:
PI4511B.” Any similar wording that expresses the same meaning may be used.
4 EU DECLARATION OF COMPLIANCE
4.1 Declaration of Conformity – BTM510
Manufacturer:
Laird Technologies
Product:
BTM510
EU Directive:
RTTE 1995/5/EC
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/ramp
12
© Copyright 2017 Laird. All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]