E5072A Datasheet, PDF (2/23 Pages) Keysight Technologies – E5072A ENA Series Network Analyzer

2 | Keysight | E5072A ENA Series Network Analyze 30 kHz to 4.5/8.5 GHz - Data Sheet
Options
This document provides technical specifications for the E5072A ENA network analyzer.
E5072A-245
E5072A-285
2-port with configurable test set, 30 kHz to 4.5 GHz
2-port with configurable test set, 30 kHz to 8.5 GHz
Calibration kits and ECal modules
This E5072A data sheet provides technical specifications for the following calibration
kits and ECal modules. For models not listed in this data sheet, please download the free
Uncertainty Calculator from www.keysight.com/find/na_calculator to generate the curves
for your calibration kit.
85032F
85033E
85092C
85093C
Calibration kit
Calibration kit
Electronic calibration (ECal) module
Electronic calibration (ECal) module
Definitions
Specification (spec.):
Warranted performance. All specifications apply at 23 ºC (± 5 ºC), unless otherwise stated,
and 90 minutes after the instrument has been turned on. Specifications include guard
bands to account for the expected statistical performance distribution, measurement
uncertainties, and changes in performance due to environmental conditions.
Typical (typ.):
Describes performance that will be met by a minimum of 80% of all products. It is not
guaranteed by the product warranty.
Supplemental performance data (SPD):
Supplemental performance data represents the value of a parameter that is most likely to
occur; the expected mean or average. It is not guaranteed by the product warranty.
General characteristics:
A general, descriptive term that does not imply a level of performance.
Boundary Conditions
In this data sheet, boundary conditions are given for the specifications. For example, sys-
tem dynamic range is 98 dB with the following boundary conditions.
Frequency: 10 MHz, IF bandwidth: 3 kHz
If the same boundary conditions fall under more than one category in a table, apply the
best value.