IS62WV12816DALL Datasheet, PDF (1/17 Pages) Integrated Silicon Solution, Inc – 128K x 16 LOW VOLTAGE, ULTRA LOW POWER CMOS STATIC RAM

IS62WV12816DALL/DBLL
IS65WV12816DALL/DBLL
128K x 16 LOW VOLTAGE,
SEPTEMBER 2011
ULTRA LOW POWER CMOS STATIC RAM
FEATURES
• High-speed access time: 35ns, 45ns, 55ns
• CMOS low power operation
– 36 mW (typical) operating
– 9 µW (typical) CMOS standby
• TTL compatible interface levels
• Single power supply
– 1.8V ± 10% Vdd (IS62/65WV12816DALL)
– 2.5V--3.6V Vdd (IS62/65WV12816DBLL)
• Fully static operation: no clock or refresh
required
• Three state outputs
• Data control for upper and lower bytes
• Industrial and Autotmovie temperature support
• 2CS Option Available
• Lead-free available
FUNCTIONAL BLOCK DIAGRAM
DESCRIPTION
The ISSI IS62/65WV12816DALL/DBLL are high-speed,
2M bit static RAMs organized as 128K words by 16
bits. It is fabricated using ISSI's high-performance
CMOS technology. This highly reliable process coupled
with innovative circuit design techniques, yields high-
performance and low power consumption devices.
When CS1 is HIGH (deselected) or when CS2 is low
(deselected) or when CS1 is low, CS2 is high and both
LB and UB are HIGH, the device assumes a standby mode
at which the power dissipation can be reduced down with
CMOS input levels.
Easy memory expansion is provided by using Chip Enable
and Output Enable inputs. The active LOW Write Enable
(WE) controls both writing and reading of the memory. A
data byte allows Upper Byte (UB) and Lower Byte (LB)
access.
The IS62/65WV12816DALL/DBLL are packaged in the
JEDEC standard 48-pin mini BGA (6mm x 8mm) and 44-
Pin TSOP (TYPE II).
A0-A16
DECODER
128K x 16
MEMORY ARRAY
VDD
GND
I/O0-I/O7
Lower Byte
I/O8-I/O15
Upper Byte
I/O
DATA
CIRCUIT
COLUMN I/O
CS2
CS1
OE
WE
UB
LB
CONTROL
CIRCUIT
Copyright © 2011 Integrated Silicon Solution, Inc.All rights reserved.ISSI reserves the right to make changes to this specification and its products at any time without
notice. ISSI assumes no liability arising out of the application or use of any information, products or services described herein. Customers are advised to obtain the lat-
est version of this device specification before relying on any published information and before placing orders for products.
Integrated Silicon Solution, Inc. does not recommend the use of any of its products in life support applications where the failure or malfunction of the product can reason-
ably be expected to cause failure of the life support system or to significantly affect its safety or effectiveness. Products are not authorized for use in such applications
unless Integrated Silicon Solution, Inc. receives written assurance to its satisfaction, that:
a.) the risk of injury or damage has been minimized;
b.) the user assume all such risks; and
c.) potential liability of Integrated Silicon Solution, Inc is adequately protected under the circumstances
Integrated Silicon Solution, Inc. — www.issi.com — 1-800-379-4774
1
Rev.  A
08/16/2011