BFP420F_12 Datasheet, PDF (17/30 Pages) Infineon Technologies AG – Low Noise Silicon Bipolar RF Transistor

BFP420F
Electrical Characteristics
Table 5-10 AC Characteristics, f = 5500 MHz
Parameter
Symbol
Maximum Power Gain
@ low noise operating point
@ recommended trade off oper. point
@ max. linearity operating point
Transducer Gain
@ low noise operating point
@ recommended trade off oper. point
@ max. linearity operating point
Noise Figure
@ low noise operating point
Minimum noise figure
Associated gain
@ recommended trade off oper. point
Minimum noise figure
Associated gain
Linearity
@ recommended trade off oper. point
3rd order intercept point at output
1 dB gain compression point at output
@ max. linearity operating point
3rd order intercept point at output
1 dB gain compression point at output
G_ma
G_ma
G_ma
S₂₁
S₂₁
S₂₁
NF_min
G_ass
NF_min
G_ass
OIP₃
OP_1dB
OIP₃
OP_1dB
Min.
–
–
–
–
–
–
–
–
–
–
–
–
–
Values
Typ. Max.
7.5 –
8.5 –
9
–
5.5 –
7
–
8
–
2.2 –
5
–
2.3 –
8
–
22
–
8.5 –
26
–
17
–
Unit Note / Test Condition
dB
Z_S = Z_SoptG, Z_L = Z_LoptG
V_CE = 3 V, I_C = 4 mA
V_CE = 3 V, I_C = 15 mA
V_CE = 4 V, I_C = 40 mA
dB Z_S = Z_L = 50 Ω
V_CE = 3 V, I_C = 4 mA
V_CE = 3 V, I_C = 15 mA
V_CE = 4 V, I_C = 40 mA
dB
Z_S = Z_SoptN
V_CE = 3 V, I_C = 4 mA
V_CE = 3 V, I_C = 15 mA
dB Z_S = Z_L = 50 Ω
V_CE = 3 V, I_C = 15 mA
V_CE = 4 V, I_C = 40 mA
Notes
1. G_ms = IS₂₁ / S₁₂I for k < 1; G_ma = IS₂₁ / S₁₂I(k-(k²-1)^1/2) for k > 1
2. In order to get the NF_min values stated in this chapter the test fixture losses have been subtracted from all
measured results.
3. OIP₃ value depends on termination of all intermodulation frequency components. Termination used for this
measurement is 50 Ω from 0.2 MHz to 12 GHz.
Data Sheet
17
Revision 1.1, 2012-11-07