TLE4926C-HTNE6747 Datasheet, PDF (11/27 Pages) Infineon Technologies AG – Dynamic Differential Hall Effect Sensor

2.1 Operating Range
TLE4926C-HTN E6747
No.
Parameter
Symbol ^{Min typ max Unit}
Remarks
2.1.1
Supply voltage
V_S
3.3
18
V Continuous
24
V 1h with R_Series ≥ 200Ω;
26
V 5min with R_Series ≥
200Ω.
Extended limits for
parameters in
characteristics.
3
V During test pulse 4
R_Series=200Ω; Ta=25°C
Limited performance
possible (jitter)
2.1.2 Supply voltage ripple
V_SAC
6
V_pp V_S=13V; 0 < f < 50kHz
2.1.3 Continuous output OFF V_Q
0
voltage
0
2.1.4 Continuous output ON
I_Q
0
current
2.1.5
Power on time
t_on
2.1.6
Operating junction
temperature
T_j
-40
18
V Continuous
24
V 1h with R_Load ≥ 500Ω
20
mA V_Qmax=0.6V
1
ms Time to achieve
specified accuracy
After power on the
output of the IC is
always in high-state.
After internal resets
output is locked⁴.
°C -
155 °C 5000 h (not additive)
165 °C 2500 h (not additive)
175 °C 500 h (not additive)
reduced signal
quality permittable
(e.g. jitter).
Note: Unless otherwise noted, all temperatures refer to junction temperature.
For the supply voltage lower than 28V (R_Series ≥ 200Ω) and junction temperature lower than
195°C the magnetic and AC/DC characteristics can exceed the specification limits.
4 _{Output of the IC is locked in present state (high-state or low-state) after an internal reset is launched.}
This reset happens typically every 780ms when there is no output switching in either case. See also
2.2.14. A voltage reset causes a release of the output and output is in high state after power on again.
Data Sheet
Page 11 of 27