XC2361B Datasheet, PDF (103/128 Pages) Infineon Technologies AG – 16/32-Bit Single-Chip Microcontroller with 32-Bit Performance

XC2361B, XC2363B, XC2364B, XC2365B
XC2000 Family / Value Line
Electrical Parameters
4.7.4 Pad Properties
The output pad drivers of the XC236xB can operate in several user-selectable modes.
Strong driver mode allows controlling external components requiring higher currents
such as power bridges or LEDs. Reducing the driving power of an output pad reduces
electromagnetic emissions (EME). In strong driver mode, selecting a slower edge
reduces EME.
The dynamic behavior, i.e. the rise time and fall time, depends on the applied external
capacitance that must be charged and discharged. Timing values are given for a
capacitance of 20 pF, unless otherwise noted.
In general, the performance of a pad driver depends on the available supply voltage
V_DDP. Therefore the following tables list the pad parameters for the upper voltage range
and the lower voltage range, respectively.
Note: These parameters are not subject to production test but verified by design and/or
characterization.
Note: Operating Conditions apply.
Table 28 is valid under the following conditions: V_DDP≤ 5.5 V; V_DDPtyp. 5 V; V_DDP≥ 4.5 V
Table 28
Standard Pad Parameters for Upper Voltage Range
Parameter
Symbol
Values
Unit Note /
Min. Typ. Max.
Test Condition
Maximum output driver I_Omax −
−
4.0 mA Driver_Strength
current (absolute value)¹⁾ CC
= Medium
−
−
10
mA Driver_Strength
= Strong
−
−
0.5 mA Driver_Strength
= Weak
Nominal output driver
I_Onom
−
−
1.0 mA Driver_Strength
current (absolute value) CC
= Medium
−
−
2.5 mA Driver_Strength
= Strong
−
−
0.1 mA Driver_Strength
= Weak
Data Sheet
103
V1.2, 2010-04