9ZXL1231_16 Datasheet, PDF (8/18 Pages) Integrated Device Technology – 12-output DB1200ZL

9ZXL1231 DATASHEET
Electrical Characteristics–DIF Low Power HCSL Outputs
T_AMB = T_COM or T_IND, unless noted., Supply Voltages per normal operation conditions, See Test Loads for Loading Conditions
PARAMETER
Slew rate
Slew rate matching
SYMBOL
dV/dt
ΔdV/dt
CONDITIONS
T_AMB = T_COM, Scope averaging on
T_AMB = T_IND Scope averaging on
Slew rate matching, Scope averaging on
MIN TYP MAX UNITS NOTES
1.5 3.3
4 V/ns 1,2,3
1.5 3.1 4.5 V/ns 1,2,3
7
20
% 1,2,4
Voltage High
Voltage Low
VHigh
VLow
Statistical measurement on single-ended signal _{660 778 850}
using oscilloscope math function. (Scope
mV
averaging on)
-150 0 150
Max Voltage
Min Voltage
Crossing Voltage (abs)
Crossing Voltage (var)
Vmax
Vmin
Vcross_abs
Δ-Vcross
Measurement on single ended signal using
absolute value. (Scope averaging off)
Scope averaging off
Scope averaging off
868 1150 _mV
-300 -64
250 430 550 mV 1,5
17 140 mV 1,6
1_{Guaranteed by design and characterization, not 100% tested in production.}
2 _{Measured from differential waveform}
3 _{Slew rate is measured through the Vswing voltage range centered around differential 0V. This results in a +/-150mV window around}
differential 0V.
4 _{Matching applies to rising edge rate for Clock and falling edge rate for Clock#. It is measured using a +/-75mV window centered on}
the average cross point where Clock rising meets Clock# falling. The median cross point is used to calculate the voltage thresholds the
oscilloscope is to use for the edge rate calculations.
5 _{Vcross is defined as voltage where Clock = Clock# measured on a component test board and only applies to the differential rising}
edge (i.e. Clock rising and Clock# falling).
6 _{The total variation of all Vcross measurements in any particular system. Note that this is a subset of Vcross_min/max (Vcross}
absolute) allowed. The intent is to limit Vcross induced modulation by setting Δ-Vcross to be smaller than Vcross absolute.
7 _{At default SMBus settings.}
Electrical Characteristics–Current Consumption
T_AMB = T_COM or T_IND, unless noted., Supply Voltages per normal operation conditions, See Test Loads for Loading Conditions
PARAMETER
SYMBOL
CONDITIONS
MIN TYP MAX UNITS NOTES
Operating Supply Current
Power Down Current
1. _{Includes VDDR if applicable}
I_DDA
I_DD
I_DDIO
I_DDA
I_DD
I_DDIO
VDDA, PLL Mode@100MHz
VDDA, PLL Bypass Mode@100MHz
All other VDD pins
VDDIO for DIF outputs, if applicable
VDDA, PLL Mode@100MHz
VDDA, PLL Bypass Mode@100MHz
All other VDD pins
VDDIO for DIF outputs, if applicable
18 20
mA
1
6
10
mA
1
16 25
mA
91 110
mA
3
5
mA
1
3
5
mA
1
0.01 1
mA
0.01 0.3
mA
12-OUTPUT DB1200ZL
8
REVISION J 05/25/16