ICS843207-350 Datasheet, PDF (10/16 Pages) Integrated Device Technology – FEMTOCLOCKS™ CRYSTAL-TO-LVPECL 350MHZ FREQUENCY MARGINING SYNTHESIZER

ICS843207-350
FEMTOCLOCKS™ CRYSTAL-TO-LVPECL 350MHZ FREQUENCY MARGINING SYNTHESIZER
PRELIMINARY
TERMINATION FOR 3.3V LVPECL OUTPUT
The clock layout topology shown below is a typical termina-
tion for LVPECL outputs. The two different layouts mentioned
are recommended only as guidelines.
FOUT and nFOUT are low impedance follower outputs that
generate ECL/LVPECL compatible outputs. Therefore, ter-
minating resistors (DC current path to ground) or current
sources must be used for functionality. These outputs are
designed to drive 50Ω transmission lines. Matched imped-
ance techniques should be used to maximize operating fre-
quency and minimize signal distortion. Figures 4A and 4B
show two different layouts which are recommended only as
guidelines. Other suitable clock layouts may exist and it
would be recommended that the board designers simulate
to guarantee compatibility across all printed circuit and clock
component process variations.
Z_o = 50Ω
FOUT
FIN
Z_o = 50Ω
50Ω
RTT =
1
((V_OH + V_OL) / (V_CC – 2)) – 2
Z_o
50Ω
V_CC - 2V
RTT
FOUT
3.3V
125Ω
125Ω
Z_o = 50Ω
FIN
Z_o = 50Ω
84Ω
84Ω
FIGURE 4A. LVPECL OUTPUT TERMINATION
FIGURE 4B. LVPECL OUTPUT TERMINATION
IDT^™ / ICS^™ LVPECL FREQUENCY MARGINING SYNTHESIZER
10
ICS843207CY-350 REV. A DECEMBER 3, 2007