ICS527-04 Datasheet, PDF (6/9 Pages) Integrated Circuit Systems – Clock Slicer User Configurable PECL input Zero Delay Buffer

ICS527-04
Clock Slicer User Configurable PECL input Zero Delay Buffer
PCB Layout Recommendations
For optimum device performance and lowest output
phase noise, the following guidelines should be
observed.
1) Each 0.01µF decoupling capacitor should be
mounted on the component side of the board as close
to the VDD pin as possible. No via’s should be used
between decoupling capacitor and VDD pin. The PCB
trace to VDD pin should be kept as short as possible,
as should the PCB trace to the ground via.
2) PECL termination networks should be located as
close to the outputs as possible.
3) An optimum layout is one with all components on the
same side of the board, minimizing vias through other
Absolute Maximum Ratings
Stresses above the ratings listed below can cause permanent damage to the ICS527-04. These ratings,
which are standard values for ICS commercially rated parts, are stress ratings only. Functional operation of
the device at these or any other conditions above those indicated in the operational sections of the
specifications is not implied. Exposure to absolute maximum rating conditions for extended periods can
affect product reliability. Electrical parameters are guaranteed only over the recommended operating
temperature range.
Item
Supply Voltage, VDD
All Inputs and Outputs
Ambient Operating Temperature
Storage Temperature
Junction Temperature
Soldering Temperature
Rating
7V
-0.5 V to VDD+0.5 V
0 to +70°C
-65 to +150°C
125°C
260°C
Recommended Operation Conditions
Parameter
Ambient Operating Temperature
Power Supply Voltage (measured in respect to GND)
Min.
0
+3.15
Typ.
+3.3
Max.
+70
+3.45
Units
°C
V
MDS 527-04 D
6
Revision 122804
Integrated Circuit Systems, Inc. ● 525 Race Street, San Jose, CA 95126 ● tel [phone] ● www.icst.com