English
Language : 

GMS30004 Datasheet, PDF (60/158 Pages) Hynix Semiconductor – 4-BIT SINGLE CHIP MICROCOMPUTERS
Chapter 5. Software
4. Commands in Each Menu
^stands for [CTRL] key, while @ stands for [ALT] key.
4.1 File Menu
Use the function key behind each command as a hot key or execute each
command through selecting [ALT]-[F] key and pressing the highlighted
character.
Load RHX F2 : Load the file named *.RHX, analyze the selected Hexa file
and disassemble it. Display the program address, assemble
code and mnemonic. The order of displayed program
addresses follows the POLYNOMIAL form. Even when the
extention is not input in case of selection, .RHX extension is
presumed to include.
Load CRF @F2 : If Cross reference file of loaded file loads the *.CRF file,
labels and variables assigned by programmer are displayed
at accurate position of Source window so that programmer
can read the program easily. Even when the extension is not
input in case of file selection, .CRF extension is presumed to
include.
Write RHX F3 : When any modifications are made to source program or
program memory after the simulator is loaded once, the
modifications are stored in the same or new filename as
loaded. It has the same command and function as > WP
[filename] of In-line command.
Log ON/OFF F4 : After the simulator is executed, all the input and results are
stored in the filename GMS30K.LOG Once function key [F4]
is pressed, log-in starts, and if the key is pressed one more
time, log-in file is closed in a toggling way. The ON/OFF
state of log-in is displayed in the upper-right corner. It has
the same function as > LOGON and > LOGOFF of In-line
commands.
Os shell @S : When users want to work temporarily under DOS environment,
this command is used. When users want to back to Windows
environment, input > EXIT.
Exit @X : Used when getting completely out of the simulator environment.
5- 6