GMS30004 Datasheet, PDF (26/158 Pages) Hynix Semiconductor – 4-BIT SINGLE CHIP MICROCOMPUTERS

Chapter 2. Architecture
Initial Reset Circuit
RESET pin must be down to ÌLÌ more than 4 machine cycle by outside
capacitor or other for power on reset.
The mean of 1 machine cycle is below. 1 machine cycle is 6/f_OSC, however,
operating voltage must be in recommended operating conditions, and clock
oscillating stability.
* It is required to adjust C value depending on rising time of power supply.
(Example shows the case of rising time shorter than 10ms.)
1
0.1uF
RESET
Watch Dog Timer (WDT)
Watch dog timer is organized binary counter of 14 steps. The selected of
f_OSC/6 cycle come in the first step of WDT. If this counter was overflowed, come
Ø ^{out reset signal automatically, internal circuit is initialized.}
The overflow time is 6 2¹³/f_OSC (108.026ms at f_OSC = 455KHz).
Normally, the binary counter must be reset before the overflow by using reset
instruction (WDTR) or / and REMOUT port (Y-reg=8, SO instruction execution) at
masked option.
* It is constantly reset in STOP mode. When STOP is released, counting is
restarted. (Refer to 1-13 STOP function>)
f_OSC/6
Binary counter
(14 steps)
RESET (edge-trigger)
CPU reset
Reset
by instruction
REMOUT
output
Mask Option
2- 7