HY29F800 Datasheet, PDF (10/40 Pages) Hynix Semiconductor – 8 Megabit (1Mx8/512Kx16), 5 Volt-only, Flash Memory

HY29F800
START
RESET# = V_ID
(All protected sector groups
become unprotected)
Perform Program or Erase
Operations
RESET# = V_IH
(All previously protected
sector groups return to
protected state)
TEMPORARY SECTOR
UNPROTECT COMPLETE
for obtaining specific data items as listed in Table
2:
n A read cycle at address 0xXXX00 retrieves the
manufacturer code (Hynix = 0xAD).
n A read cycle at address 0xXXX01 returns the
device code:
- HY29F800T = 0xD6 in Byte mode, 0x22D6
in Word mode.
- HY29F800B = 0x58 in Byte mode, 0x2258
in Word mode.
n A read cycle containing a sector address (Table
1) in A[18:12] and the address 0x02 in A[7:0]
returns 0x01 if that sector is protected, or 0x00
if it is unprotected.
Figure 3. Temporary Sector Unprotect
DEVICE COMMANDS
Device operations are initiated by writing desig-
nated address and data command sequences into
the device. A command sequence is composed
of one, two or three of the following sub-segments:
an unlock cycle, a command cycle and a data
cycle. Table 4 summarizes the composition of the
valid command sequences implemented in the
HY29F800, and these sequences are fully de-
scribed in Table 5 and in the sections that follow.
Writing incorrect address and data values or writ-
ing them in the improper sequence resets the
HY29F800 to the Read mode.
Read/Reset 1, 2 Commands
The HY29F800 automatically enters the Read
mode after device power-up, after the RESET#
input is asserted and upon the completion of cer-
tain commands. Read/Reset commands are not
required to retrieve data in these cases.
A Read/Reset command must be issued in order
to read array data in the following cases:
n If the device is in the Electronic ID mode, a
Read/Reset command must be written to re-
turn to the Read mode. If the device was in the
Erase Suspend mode when the device entered
the Electronic ID mode, writing the Read/Re-
set command returns the device to the Erase
Suspend mode.
10
Table 4. Composition of Command Sequences
Command
Sequence
Number of Bus Cycles
Unlock Command Data
Read/Reset 1
0
1
Note 1
Read/Reset 2
2
1
Note 1
Byte Program
2
1
1
Chip Erase
4
1
1
Sector Erase
4
1
1 (Note 2)
Erase Suspend 0
1
0
Erase Resume
0
1
0
Electronic ID
2
1
Note 3
Notes:
1. Any number of Flash array read cycles are permitted.
2. Additional data cycles may follow. See text.
3. Any number of Electronic ID read cycles are permitted.
Note: When in the Electronic ID bus operation mode,
the device returns to the Read mode when V_ID is re-
moved from the A[9] pin. The Read/Reset command is
not required in this case.
n If DQ[5] (Exceeded Time Limit) goes High dur-
ing a program or erase operation, writing the
Read/Reset command returns the sectors to
the Read mode (or to the Erase Suspend mode
if the device was in Erase Suspend).
The Read/Reset command may also be used to
abort certain command sequences:
Rev. 4.2/May 01