HMC618ALP3E Datasheet, PDF (16/16 Pages) Hittite Microwave Corporation – GaAs SMT pHEMT LOW NOISE AMPLIFIER, 1.2 - 2.2 GHz

v00.1014
Evaluation PCB, 1200 to 1700 MHz Tune
HMC618ALP3E
GaAs SMT pHEMT LOW NOISE
AMPLIFIER, 1.2 - 2.2 GHz
7
Evaluation PCB Ordering Information
List of Materials for Evaluation PCB
Item
Evaluation PCB
Content
HMC618ALP3E
Evaluation PCB
Part Number
EV1HMC618ALP3
The circuit board used in this application should use
RF circuit design techniques. Signal lines should
have 50 Ohm impedance while the package ground
leads and exposed paddle should be connected
directly to the ground plane similar to that shown.
A sufficient number of via holes should be used to
connect the top and bottom ground planes. The
evaluation board should be mounted to an appro-
priate heat sink. The evaluation circuit board shown
is available from Hittite upon request.
Item
Description
J1, J2
PCB Mount SMA RF Connector
J3 - J5
DC Pin
C1
10 nF Capacitor, 0402 Pkg.
C2, C4
1000 pF Capacitor, 0603 Pkg..
C3, C5
0.47 µF Capacitor, 0603 Pkg.
C6
100 pF Capacitor, 0402 Pkg.
C7
3 pF Capacitor, 0402 Pkg.
L1
27 nH, Inductor, 0603 Pkg.
L2
5.6 nH, Inductor, 0603 Pkg.
L3
18 nH, Inductor, 0603 Pkg.
R1
470 Ohm resistor, 0402 Pkg.
U1
PCB ^[1]
HMC618LP3(E) Amplifier
600-00077-00 Evaluation PCB
[1] Circuit Board Material: Rogers 4350.
For price, delivery and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824
978-250-3343 tel • 978-250-3373 fax • Order On-line at www.hittite.com
Application Support: [e-mail]
7 - 14